Gamewell-FCI B200SR Sounder Base

Non Addressable Devices Series B200SR Sounder Base B200SR Series sounder base sets a new standard for performance installation aesthetics It is a non addressable base that is available in both Velociti and protocols The B200SR is designed for new and existing dwelling unit It offers maximum flexibility in installation configuration and operation comply or exceed the UL Standard 268 and UL Standard 464 requirements B200SR is fully compatible and is a replacement for the existing B501BH Series base installations By removing a jumper the device enables users to select of two B501 supported tones ANSI Temporal 3 or Continuous its attractive aesthetics the B200SR is ideal for use with applications where is critical For example the sounder base employs a separate mounting that installs on various junction box sizes to eliminate unsightly surface mount refer to Table 1 In addition the mounting plate enables pre wiring of all to simplify the installation To install the housing use the mounting and secure two retaining screws to lock it in position The retaining screws are by the installed sensor head for added tamper resistance The E3 Series and S3 Series panels support both the Velociti and the CLIP and the GWF 7075 panel supports only the Velociti protocol GANGE mm mm mm mm SQUARE W MUD RING 1 B200SR Junction Box Selection Guide Information Intelligent Non Addressable Sensor Sounder Base bright white Intelligent Non Addressable Sounder Base ivory 1 The B200SR WH and B200SR IV can produce a sound output with ANSI Temporal 3 or continuous tone Use the B200SR and B200SR IV for retrofit applications 2 Use the B200SR WH and B200RS IV with the 7100 Series E3 Series S3 Series and GWF 7075 fire alarm control panels BENEFITS Complies with UL 268 and UL 464 Provides a tone via an on jumper Offers a pre wire Includes a mechanical plate that various box sizes feature that the removal of attached sensor Fully compatible with existing B501BH sounder base B200SR is designed to comply with the following Standards UL 268 UL 464 LISTINGS AND APPROVALS listings and approvals apply to the modules in this document In some cases certain or applications may not be listed by certain agencies or listing may be in process factory for latest listing status S1911 3035027 7135 1653 213 9001 Certification a complete listing of all approvals and please visit Series Velociti and are registered of Honeywell Inc is a registered trademark Underwriter Laboratories document is not intended be used for installation We try to keep our information up to and accurate We cannot all specific applications anticipate all requirements specifications are subject to without notice Series B200SR Technical Specifications Specifications Diameter 6.875 17.46 cm Height 2.0 5.08 cm less sensor Weight 0.50 lb 227 gm Temperature Range For information on the sensor operating temperature range refer to Base Sensor Cross Reference Chart at Humidity Range 10 to 93 relative non condensing Specifications Supply Voltage 16 to 33 VDC VFWR Current 500 uA maximum Current 35 mA maximum Operating Voltage 15 to 32 VDC Standby Current 300 uA maximum Output Volume Greater than 85 dBA minimum in a UL reverberant room at 10 ft 24 Volts in tone Volume Greater than 75 dBA minimum measured a UL reverberant room at 10 feet 24 Volts in tone AND HUMIDITY RANGES system meets NFPA requirements for operation at 0 49 120 and at a relative humidity 93 2 noncondensing at 32 2 90 3 the useful life of the system s standby batteries the electronic components may be adversely affected extreme temperature ranges and humidity Therefore is recommended that this system and its peripherals be in an environment with a normal room of 15 27 80 more information more about Gamewell FCI Velociti Series B200SR and products available by visiting www Gamewell FCI com Gamewell FCI Clintonville Road CT 06472 1610 H 05 2019 Honeywell International Inc