Gamewell-FCI DACT-E3 Digital Alarm Communicator Transmitter

DACT E3 Alarm Communicator Transmitter DACT E3 is the digital communication used with the E3 Series and S3 Series Digital Alarm Communicator Transmitter is a digital communications circuit is an optional component of the following E3 Series Expandable Emergency DACT E3 is adaptable for installation in standard E3 Series and S3 Series System Typically the DACT E3 module on standoffs on top of the left side of ILI MB E3 ILI95 MB E3 or SLP Smart Panel module Either unit can be easily to the backbox or sub assembly depending on the cabinet module instructions on how to install the DACT E3 to the following documents E3 Series Expandable Emergency S3 Series Small Addressable Fire Alarm System Panel DACT E3 sends digital signals over the network that transmits to a central This module can be located in the cabinet or remotely located via a local serial interface DACT E3 is compatible with digital alarm receivers DACRs that receive following signaling formats SIA DC83 1 2300 Hz SIA DCS204 2 1400 Hz Ademco Contact ID4 2 2300 Hz 3 1 1400 Hz addition to the DACT E3 being compatible digital signaling formats the DACT E3 numerous formats for to a central station As a communicator the DACT E3 complies FCC Part 8 Telecommunication for DC and AC Ringer Equivalence AND BENEFITS Listed under UL Standard 864 10th via the RS 485 E3 Series ILI MB E3 ILI95 MBE3 S3 Series SLP Manual DACT E3 Installation Instructions S3 Series Small Addressable Fire Alarm Panel UL Listing Document INFORMATION Digital Alarm Communicator Sends information in a variety of formats Traces proper central station and full Contact ID tone Transmits and verifies data to the central Offers pre programmed dialing to the Activates hang up and release phone lines Compatible with the IPDACT Internet Communicates with the following sub Performs on and off hook status to the station phone number lines TECHNICAL SPECIFICATIONS Voltage 24 VDC from the PM power supply Current 0.018 amp Current 0.018 amp Temperature 32 to 120 F to 49 C Humidity 0 to 93 at 90 F 32 C AND HUMIDITY RANGES system meets NFPA requirements for at 0 49 120 and at a humidity 93 2 RH noncon at 32 2 90 3 How the useful life of the system s standby and the electronic components be adversely affected by extreme tem ranges and humidity Therefore it recommended that this system and its be installed in an environment a normal room temperature of 15 80 DACT E3 is designed to comply with the standard Standard UL 864 10th Edition LISTINGS AND APPROVALS and approvals apply to the specified in this document In some certain modules or applications may not listed by certain approval agencies or listing be in process Consult the factory for the listing status Listed S1869 UL 864 10th Edition Approved 3025415 FDNY COA 6077 7165 1703 0125 of Chicago Class 1 Class 2 and High Rise of Denver Series Velociti Series and are registered of Honeywell Inc is a registered trademark of Laboratories Inc document is not intended to be for installation purposes We to keep our product information and accurate We cannot all specific applications or all requirements All are subject to change notice of origin U S A Gamewell FCI Clintonville Road CT 06472 1610 M 06 20 Honeywell International Inc