Gamewell-FCI Digital Alarm Com Transmitter - GW-UDACT

File Preview
File Preview
Click below to download for free

File Data

Name gamewell-fci-digital-alarm-com-transmitter-gw-udact-8571920643.pdf
Type PDF
Size 747.50 KB
Downloads

Text Preview

Description Gamewell FCI Universal Digital Alarm Communicator GW UDACT is designed for use with all 600 Series Fire Alarm Control Panels The transmits the system status to UL Listed Cen Station Receivers via the public switched telephone GW UDACT is compact in size and mounts directly in panel RS 485 annunciator communications bus and 24 volt connections are required GW UDACT is capable of transmitting the following of software zones and Trouble Trouble Trouble Off Normal Battery Fail GW UDACT is also capable of transmitting the status all zones associated with each panel Reporting is in the of software zones or groups up to 256 Each zone be programmed for fire waterflow supervisory etc Descriptions regarding point capacity listed above used for receivers which receive in the Ademco ID format For compatible receivers refer Table 1 page 2 Specifications Universal Digital Alarm Communicator Transmitter shall continuously supervise the state of of the two connected Telco Lines at approximately intervals by a Line DC level measurement If fails a Line 1 or Line 2 Trouble event will be Once a line has been restored a Line Trouble event will be reported The unit shall be capable reporting Alarm Trouble Supervisory and Waterflow and event specific restorals for each of up to 256 or software zones The product will always report sorted in the order in which they are received recog GW UDACT shall be capable of reporting multiple to a single account number within a single call ses Up to three attempts for a single message not yet will be made within a single call attempt A failure communicate to either or both accounts will generate a event which will be queued for reporting unit shall be a Gamewell FCI model GW UDACT is a registered trademark of Underwriters Laboratories Inc Digital Alarm Transmitter GW UDACT per ANSI UL 864 9th Edition Maximum of 14 point trouble messages transmitted phone lines and telephone line voltage detect technology and mounts directly in in size 6.75 x 4.25 17.145 x 10.795 cm programmer four character red seven segment LED display Manual test report function vital system status including Independent zone fire alarm and non fire alarm Independent zone trouble and non zone trouble Independent zone supervisory AC mains power loss programmable Low battery and earth fault System off normal 12 or 24 hour test signal Abnormal test signal per UL requirements RS 485 communication bus failure of UDACT troubles including loss of lines communication failure with either central total communication failure mode converts keypad to DTMF touch LEDs for power RS 485 loss manual test off communication fail primary line seize sec line seize and modem communications collector relay driver for total communications or UDACT trouble clock transient protection ISO 9000 2000 Company Clintonville Road Northford CT 06472 Tel 203 484 7161 Fax 203 484 7118 are for information only are not intended for installation purposes and subject to change without notice No responsibility is assumed by Gamewell FCI for their use Gamewell FCI All rights reserved www gamewell fci com Rev C page 1 of 2 Receivers 1 lists the compatible receivers for the GW UDACT 16 42 1 1 Ademco Express 2 Ademco Express 1 Standard 1800 2300 USED USED USED USED USED USED Contact ID USED 2 2 2 2 2 2 4 4 4 4 4 4 8 5,6 5 5 1 Compatible Receivers With 685 8 Line Card with Rev 4.4d software With 9002 Line Card Rev 9035 software or 9032 Line Card with 9326A software Rev 4.0 software FBI CP220FB Rec 11 Line Card with Rev 2.6 software and a memory card with Rev 3.8 software Model 6500 with Rev 600 software Model 6000 with Rev 204 software With Rev B control card at Rev 1.4 software and Rev C line card at Rev 1.5 software Model 2 only Version 1.62 software Information Number Model Universal Digital Alarm Transmitter for use with Gamewell FCI 600 Series panels operating and programming and mounting phone cord 7 ft 2.13 m long required volts DC Voltage A Current While Communicating 0.075 A VDC Voltage Formats 3 1 Standard 4 1 Standard 4 2 Standard 4 1 and 4 2 Ademco Express Ademco Contact ID The Ademco Contact ID must be used for indepen zone reporting the GW UDACT is used with the Gamewell FCI Series the GW UDACT mounts directly in the panel Humidity Rating non condensing F 120 F C 49 C Rev C page 2 of 2 www gamewell fci com Clintonville Road Northford CT 06472 Tel 203 484 7161 Fax 203 484 7118

Related Files