Gamewell-FCI FCI-CHG-120 Battery Charging System

Voice Evacuation Charging System FCI CHG 120 is the compatible battery charging system that is designed for use the AA 100 and the AA 120 bulk amplifiers It is used to charge lead acid between 25 and 120 ampere hours A H and Features FCI CHG 120 consists of a PC board and a mounting chassis The FCI CHG 120 the following Diagnostic LEDs Primary AC ON Charger Trouble Battery Voltage Level 3 LEDs the following charge amperes hours 24 AH batteries within 9 hours 55 60 AH batteries within 20 hours 120 AH batteries within 38 hours Ground Fault Low Battery Lo Charge Hi Charge the FCI CHG 120 Battery Charging System when the batteries are required for between 25 to 120 A H The FCI CHG 120 has the capability to charge two A H batteries or two 50 A H batteries can install the FCI CHG 120 within 20 ft 6.096 m from the main fire alarm panel There are a variety of mounting options available for the FCI CHG 120 FCI CHG 120 can be mounted in the CAB 4 Series backbox or the FCI LBB backbox used for remote installations BENEFITS Complies with the Conforms to NFPA 72 Charges sealed lead Obtains a full float Offers ratings for UL Standards fire alarm systems UL Standard 864 for control units UL Standard 1481 for power supplies Fire Alarm Operates on any 24 FACP that requires specified batteries can disable the charger batteries within 48 hours Includes an automatic Supports AC fail delay battery station per the NFPA Standards of 25 to 120 Provides Form C contact and outputs for easy distribution Information Battery charger circuit board and chassis Includes mounting hardware installation instructions 26 A H 12 volt sealed lead acid 55 A H 12 volt sealed lead acid battery 100 A H 12 volt sealed lead acid Battery backbox black battery backbox holds the following two BAT 12550 55 A H batteries or one BAT 121000 100 A H battery Backbox 24 W x 14 H x 7.75 D 61 W x 35.6 H x 19.7 D cm 24.125 W x 14.25 H x 0.063 D 61.3 W x 36.2 H x 0.16 D cm Series Backbox Installation mount the FCI CHG 120 to the CAB 4 Series do the following Mount the FCI CHG 120 in the main power position on the lower left corner of the Series backbox Position the FCI CHG 120 in the lower right usually located where the batteries are of the CAB 4 Series backbox To secure the FCI CHG 120 to the CAB 4 Series use self tapping screws Backbox Remote Installation mount the FCI CHG 120 to the FCI LBB Series do the following Mount the FCI CHG 120 in the left side of the backbox To secure the FCI CHG 120 to the FCI LBB backbox use self tapping screws one 55 A H battery or two A H batteries will with the charger board in the BB FF FCI LBB The following list the types of batteries Up to two 26 A H batteries Up to two 55 60 A H batteries One 100 A H battery the FCI CHG 120 is mounted internally the batteries can be used Up to two 26 A H batteries Up to two 55 60 A H batteries One 100 A H battery the 100 A H batteries are required use an FCI backbox to mount each 100 A H battery The FCI can mount in either the CAB 4 Series or a third FCI LBB backbox in this Technical Specifications AC TB1 115 VAC 60 Hz 2 A 230 VAC Hz 1 Relay TB3 5 A 30 VDC Charge Voltage 27.6 VDC Charging Current 4.5 A F1 F3 15 A Sizes 25 A H to 120 A H time to charge two 2 fully discharged 25 A H battery 9 hours charging time A H battery 20 hours charging time A H battery 38 hours charging time AND HUMIDITY RANGES system meets NFPA requirements for operation at 49 120 and at a relative humidity 93 RH noncondensing at 32 2 90 3 the useful life of the system s standby and the electronic components may be affected by extreme temperature ranges and Therefore it is recommended that this and its peripherals be installed in an with a normal room temperature of 15 80 FCI CHG 120 is designed to comply with the standards Standards 864 9th Edition for controls 1481 for power supplies LISTINGS AND APPROVALS listings and approvals apply to the modules in this document In some cases certain or applications may not be listed by certain agencies or listing may be in process the factory for the latest listing status Listed S674 Approved 3022355 Approved 195 97 E 345 02 E 317 07 E Approved 6026 7165 1703 0125 6911 1703 0118 Approved CS118 CS733 Vol 9 9001 Certification a complete listing of all approvals and please visit is a registered trademark Underwriters Laboratories document is not intended be used for installation We try to keep our information up to and accurate We cannot all specific applications anticipate all requirements specifications are subject to without notice more information more about Gamewell FCI FCI CHG 120 and other available by visiting www Gamewell FCI com Gamewell FCI Clintonville Road CT 06472 1610 D 09 17 Honeywell International Inc