Gamewell-FCI FF8 NAC Expander Power Supply

FireForce 8 Expander Power Supply FireForce 8 FF8 from Gamewell FCI is a Notification Circuit NAC extender panel designed to extend power capabilities of existing NACs and provide power A for other ancillary devices The FF8 will connect to brand of a UL Listed Fire Alarm Control Panel FACP provide Notification Appliance Circuit expansion with advanced switch mode power supply tech the FireForce 8 provides filtered and electronically power distributed to four 4 NACs Each NAC is at 3.0 Amp maximum with a total output capacity of Amp The outputs may be configured as the following 4 Class B Style W X Y 2 Class A Style Z 2 Class B and one Class A 4 Class A Style Z with the optional Class A installed FF8 includes an internal battery charger FF8 provides independent output circuit In the event of a NAC fault the FF8 can be to notify the FACP The FF8 has field select built in strobe and horn sync protocols Protocols Faraday Gentex System Sensor Amseco and devices or pass through a pre gener sync protocol from a single synchronization source eliminates the need for additional individual sync mod Independent horn silencing via sync protocol allows horns and strobes to operate on a single cir of the most challenging aspects of a retrofit application locating the existing EOL resistor In retrofit applications have EOL values other than the 3.9K ohm EOL resis normally used with the FF8 a single resistor matching existing EOL can be used as a reference EOL for all This feature speeds installation and system check The reference resistor must be within a range of 2K to 25K ohm 8 labeling is placed on the cabinet front mak the FF8 ideal for all retrofit applications enhanced notification appliance circuit survivability the can utilize its dual activation inputs for redundant trip 8 two fully supervised input control circuits activation option for survivability Multiple sync protocols compatible with the following Cooper Wheelock Faraday System Sen Amseco and Gentex as field selectable options 4 configurable supervised NAC outputs Amp 24 VDC fully regulated full load output fault notification to FACP A auxiliary power output trouble and status LEDs trouble Form C relay AC Fail Form C relay immediate or delayed hours fault detection AH battery charger capability temporal coding multiple NAC synchronization for large multipack for up to four FF8s in a single lock enclosure Class A adaptor ISO 9000 2000 Company are for information only are not intended for installation purposes and are subject to change without notice No responsibility is assumed by Gamewell FCI for their use Clintonville Road Northford CT 06472 1610 USA Tel 203 484 7161 Fax 203 484 7118 by Honeywell International Inc All rights reserved Rev a page 1 of 2 Continued Control Circuit 16 30 VDC 5 mA minimum Rating 32 to 120 0 to 49 Humidity 93 non condensing Cabinet H x 12.5 W x 4.5 D H x 31.75 W x 11.43 D cm Cabinet H x 24.0 W x 6.0 D H x 60.96 W x 15.24 D cm Selectable NAC Signaling Follows Input SYNC with Noise Eliminated Information VDC 8.0 Amp fire alarm NAC power supply with integral charger cabinet with one FF8 and for up to three additional FF8 CMs 31085s See Options Section assembly version of FF8 for in FF8 MP spaces A adaptor converts signal circuits Class A wiring See Options Section plate for placing up to two modules into the FF8 and FF8 MP compatible See Section plate for placing XP95 devices the FF8 MP includes standoffs for devices 12 VDC 7 AH required for 24 V operation 31081 Battery 12 VDC 12 AH required for 24 V operation Specifications Fire Alarm System shall be designed with remotely Notification Appliance Circuit NAC Expander Supplies for the support of notification appliances remote Power Supplies shall be fully supervised and provide 8.0 Amps of notification appliance power and Amps of auxiliary power output The NAC Extender shall be able to select strobe synchronization proto via an internal dip switch There shall be five selectable available The NAC Extender Panel shall syn all outputs simultaneously The NAC Extender shall be able to use existing notification appliance end of line resistors in the range of 2K 25K ohms retrofit applications The internal battery charging circuit charge up to 26 AH batteries The NAC Expander Supply shall be a Gamewell FCI FireForce 8 mounting plate provides a means to install two 2 modules The addition of SCE 95s provides a to run on FF8 outputs via a panel command on an The 31081 mounts over the main PCB and is hinged access to FF8 terminal FF8 option provides a means to place up to four FF8s or 31085s XP95 device mounting plates in a sin lockable enclosure UL approved A adaptor converts the four 4 Class B outputs to 4 Class A outputs Input Power 120 VAC 60 Hz 3.0 A Power Charging Space Output Power Current Power 220 V 1.5 A jumper selectable operation two 7 24 AH to 26 AH batteries to two 12 AH batteries maxi inside the FF8 cabinet batteries require a separate cabinet A maximum A A under all conditions A if load is removed during external relay or AC relay use required Output Ratings 24 VDC fully regulated 3.0 A per circuit 8.0 A total Resistor Trouble AC Fail Relay 2.0 A 28 VDC or 120 VAC to 25K 1 2 watt Rev a page 2 of 2 Clintonville Road Northford CT 06472 1610 USA Tel 203 484 7161 Fax 203 484 7118