Gamewell-FCI HPF24S6 & HPF24S8 Power Supply & Battery Charger

HPF24S6 and Supplies with Battery Chargers HPF24S6 and HPF24S8 are compact cost effective 6 or 8 amp remote power supplies with integral battery These adaptable power supplies may be con to any 12 or 24 volt Fire Alarm Control Panel or the power supplies may stand alone Primary include the following Notification Appliance Circuits NAC expansion to sup ADA requirements and NAC synchronization Auxiliary power to support 24 volt system accessories power supplies provide regulated and filtered 24 power to four 4 notification appliance circuits con as either four 4 Class B Style Y or Class A A with ZNAC 4 Option Module Alternately the four may be configured as follows all non resettable all resettable power supplies also contain a battery charger with a capacity of up to 18 Amp Hour batteries non resettable resettable HPF24S6 and HPF24S8 power supplies comply with following Agency standards NFPA 72 National Fire Alarm Code UL Standard 864 9th Edition for control units for Fire Systems NAC expander mode UL 1481 Power Supplies for Fire Alarm Systems mode UL Listed NAC synchronization using System Sensor or Gentex Commander Series Uses a cascade of up to ten 10 power supplies or 4 power supplies with Gentex with strobe timing Operates as a sync follower or a sync generator Contains two 2 fully isolated input control circuits from FACP notification appliance circuit expander mode or jumpered permanently on mode Configured to internally house an addressable SLC con module for alarm activation Supports four 4 Class B Style Y or four 4 Class A Z with ZNAC 4 Module notification appliance Provides 6.0A or 8.0A depending on model full load 3.0A maximum per circuit in NAC expander UL Standard 864 Uses 4.0A or 6.0A continuous output in the stand alone UL Standard 1481 is a registered trademark for Underwriter Laboratories Inc GAMEWELL FCI are for information only are not intended for installation purposes and are subject to change without notice No responsibility is assumed by Gamewell FCI for their use Clintonville Road Northford CT 06472 1610 USA Tel 203 484 7161 Fax 203 484 7118 by Honeywell International Inc All rights reserved www gamewell fci com Rev B page 1 of 2 Continued Circuits Continued 4.0A maximum total continuous current for all outputs mode for the HPF24S6 and 6A for the 6A or 8A depending on the model maximum total current for all outputs NAC Expander mode Power Battery Charging Circuit Supports lead acid batteries only Float Charge Voltage 27.6 VDC Maximum Charge Current 1.5A Maximum Battery Capacity 18 AH Information Number charger 6A power supply VAC Includes the main printed board transformers red and installation instructions charger 8A power supply VAC Includes the main printed board transformers red and installation instructions Replacement mother board A Style Z NAC option module 12 volt 7.0 AH two required Continued stand alone mode output power circuits are config as resettable using the FACP reset switch or a combination of both Fully regulated and filtered power output optimal for four wire smoke detectors annunciators and system peripherals requiring regulated filtered Class 2 Power Limited technology complies with UL 2 Power Limited requirements a normally closed trouble relay Provides fully supervised power supply battery and appliance circuits Selectable earth fault detection AC trouble report selectable for immediate or up to an 8 delay Compatible with any UL Standard 864 fire alarm control which uses an industry standard reverse polarity notification circuit including unfiltered and unregu bell power Requires input trigger voltage of 9.0 32 VDC Built with a self contained compact lockable cabinet H x 14.5 W x 2.75 D 38.1 H x 36.8 W x 7.0 D cm an integral battery charger capable of charging to 18 AH batteries The cabinet has the capacity of 7.0 AH batteries Battery charger may be disabled via a DIP Dual In Line switch for applications requiring larger Offers fixed clamp type terminal blocks that up to 12 AWG 3.1 mm2 wire AC Power HPF24S6 120 VAC 60 Hz 3.2A maximum HPF24S8 120 VAC 60 Hz 3.2A maximum Wire size minimum 14 AWG 2.0 mm with 600V Voltage 9.0 to 32 VDC Current 2.0 mA 16 32 V Input Circuit per input 1.0 mA 9 16 V Contact Rating 5.0A at 24 VDC Power Output Specific Application Power 500 mA maximum Circuits 24 VDC filtered regulated 3.0A maximum for any one circuit Rev B page 2 of 2 Clintonville Road Northford CT 06472 1610 USA Tel 203 484 7161 Fax 203 484 7118