Gamewell-FCI HPFF8 NAC Expander Power Supply

HPFF8 Expander Power Supply Gamewell FCI HPFF8 is a Notification Appliance Cir NAC expansion panel designed to extend the power of existing NACs and provide power for the devices The HPFF8 connects to any 12 or 24V Alarm Control Panel FACP or stand alone HPFF8 is available in 8.0 amps It provides regulated filtered 24VDC power to each of the four NACs and an output The NAC outputs are rated at 3.0 amps the total output cannot exceed 8.0 amps The auxil output is rated at 2.0 amps This output is continuously even in alarm and therefore must be taken into for power supply loading and battery size calcula NAC outputs may be configured as any of the follow Four Class B Style Y Two Class A Style Z Two Class B and one Class A Four Class A with the optional HPP31076 Class A installed power supplies contain an internal Battery charger of charging up to 26.0 amp hour AH batteries HPFF8 is mounted in lockable wall cabinet units that accommodate up to two 2 18AH batteries A multi option allows for up to four chassis mount units in a single lockable SBB D4 enclosure These mount units have a CM suffix HPFF8CM and accommodate two 12AH batteries Power supplies are in either 120VAC 60 Hz or 240VAC 50 Hz of the most challenging aspects of a retrofit applica is locating the existing End of Line EOL resistor In applications that have EOL values other than the normally used with the HPFF8 a single resistor the existing EOL can be used as a reference for the outputs This feature speeds the installation and the checkout because the actual EOL does not need be located and changed in the circuit The reference must be within the range of 1.9k to 25k Four 4 supervised notification application circuits capable of supplying 24VDC at 3.0 amp each NAC output circuits may be configured as any of the Four Class B Style Y Two Class A Style Z Two Class B one Class A Four Class A with the HPP31076 Class A installed Four field programmable operational modes 2.0 amp auxiliary continuously supplied output Two 2 fully supervised input output control circuits Temporal coding and sync protocols compatible with following notification appliance brands System Sensor Gamewell Cooper Wheelock Faraday Amseco Gentex Supervised AC input battery voltage auxiliary output and earth ground faults Trouble indication for supervision of the following NAC circuits AC input Battery voltage Earth ground faults by individual status LED Auxiliary output Charger Open contacts in the initiat ing device signal inputs for FACP trouble notification Separate Trouble and AC Fail Form C relay Contacts ISO 9001 2000 Company are for information only are not intended for installation purposes and are subject to change without notice No responsibility is assumed by Gamewell FCI for their use Clintonville Road Northford CT 06472 1610 USA Tel 203 484 7161 Fax 203 484 7118 by Honeywell International Inc All rights reserved Rev B page 1 of 2 Continued The Trouble Form C relay contacts selectable for imme or a 2 hour delay with AC failure 26 AH battery charger capability the wall cabinet two 12V 18AH batteries while the multi pack cabinets supports two 12V 12AH batteries NAC Overload protection and indication Up to four chassis mount units HPFF8CM can be in the SBB D4 backbox Wall mount units can be configured to internally house following one AOM 2SF single control module one AOM 2R single relay module Charging Capacity Up to 26 AH batteries Input Power Power Space HPFF8 Cabinet SBB D4 Cabinet Output Power Current Power Output 3.6A or 1.5A volt operation 2 7 24 AH batteries to two 18AH batteries to two 12AH batteries supply max A under all conditions if load is removed dur operation external relay AC Fail Relay is required Continued Output Ratings Resistor Trouble Relay AC Relay Control Circuit Rating Humidity Dimensions HPFF8 Cabinet SBB D4 Cabinet fully regulated 3.0A per circuit 8.0A total to 25k ohm watt at 28VDC or 120VAC 5mA min to 120 0 to 49 to 93 W x 19.0 H x 5.2 D W x 48.26 H 13.23 D cm W x 45.9 H x 5.15 D W x 116.52 H x 13.1D cm Information Number fire rated power supply operating at Hz Unit includes red with HPP lock and key fire rated power supply chassis operating at 120VAC 60 Hz includes mounting hardware for in the SBB D4 enclosure fire rated power supply operating at Hz fire rated power supply chassis operating at 240VAC 50 Hz A Style Z NAC module door PK 625 lock and key for backbox black accepts up to 4 chassis Rev B page 2 of 2 Clintonville Road Northford CT 06472 1610 USA Tel 203 484 7161 Fax 203 484 7118