Gamewell-FCI PM-9G Power Supply Battery Charger

PM 9G and Networking Systems VAC Power Supply and Battery Charger Gamewell FCI PM 9G Power Supply is a 220 240 VAC 50 60 Hz switching supply It provides power to the Fire Alarm Control Panel INCC Command INX Transponder sub assemblies and all the E3 Series components PM 9G is a component of the following systems E3 Series Expandable Emergency Evacuation System E3 Series Combined Fire Alarm and Mass Notification Systems E3 Series Broadband Voice Evacuation System includes 9 amperes of filtered and regulated 24 VDC FWR In addition it has an battery charging circuit that is capable of maintaining up to 55 A H batteries the PM 9G Module can be mounted in the following E3 Series cabinets Cabinet B Fire Alarm Control Panel Cabinet C INCC Command Center Cabinet C INX Audio Transponder Cabinet D INCC Command Center Cabinet D INX Audio Transponder information on the PM 9G installation refer to the following documents E3 Series Manual P N LS10080 051GF E PM 9G Installation Instructions P N 9001 0055 Mass Notification System Installation Operation Manual P N LS10013 000GF E Information Power Supply and Battery Charger 220 240 VAC AC Line Filter Kit BENEFITS Listed under UL 864 9th Includes 9 ampere regulated supply technology Offers energy and Contains an integral charger of recharging to 55 A H batteries not Listed under UL UL2572 for Notification Provides 1 ampere charging PM 9G is designed to comply with the following Standards UL 864 9th Edition 2572 for Mass Notification LISTINGS AND APPROVALS listings and approvals apply to the modules in this document In some cases certain or applications may not be listed by certain agencies or listing may be in process Consult factory for the latest listing status Listed S1869 Vol 14 S1949 Vol 19 FDNY COA 6077 7165 1703 0125 9001 Certification a complete listing of all approvals and please visit Series and Gamewell FCI registered trademarks of International Inc is a registered trademark Underwriters Laboratories document is not intended be used for installation We try to keep our information up to and accurate We cannot all specific applications anticipate all requirements specifications are subject to without notice Technical Specifications Voltage 220 240 VAC 50 60 Hz Current 2.4 amps max Voltage 24 VDC FWR Current 9 amperes Alarm maximum Current 5 amps maximum continuous when the PM 9G is used with the ILIE3 or ILI95 E3 Series See Note 1 Current 4 amps maximum continuous when the PM 9G is used with any AM 50 amplifier See Note 1 Current 1 amp battery charging current Current 0.050 amp Temperature 32 to 120 F 0 to 49 C Humidity 0 to 93 non condensing at 90 F 32 C 10 1 2 W x 5 H x 2 D 27 W x 13 H x 5 D cm and Non Power Limited 1 Continuous standby loads in excess of 560 Amps to 5 Amps or 4 Amps may require a Generator Backup load shedding during an AC power failure AND HUMIDITY RANGES system meets NFPA requirements for operation at 0 49 120 and at a relative humidity 93 2 noncondensing at 32 2 90 3 the useful life of the system s standby batteries the electronic components may be adversely affected extreme temperature ranges and humidity Therefore is recommended that this system and its peripherals be in an environment with a normal room of 15 27 80 more information more about Gamewell FCI PM 9G and other products by visiting www Gamewell FCI com Gamewell FCI Clintonville Road CT 06472 1610 J 09 17 Honeywell International Inc