Gamewell-FCI Projected Beam Detector - Fire Ray

Fire Ray Ray Beam Detector Ray Beam Detector in a single compact housing Eliminates the need to wire between the transmitter and receiver Designed with ease of installation and beam alignment Equipped with an automatic gain control to compensate integral alignment aid gradual dust build up Provides latching or non latching alarm options Controlled by a Microprocessor Uses low current consumption Has 12 24 VDC operating voltage Allows field selectable sensitivity settings of 25 35 50 per ft obscuration Projects beam ranges 50RU 100RU 15 ft to 160 ft 5m to 50m 160 ft to 330 ft 50m to 100m alarm and trouble dry contacts Offers the following indicating LEDs Amber Trouble Red Alarm 7002 E Fire Ray is a new generation of the reflective beam detector The Fire Ray incorporates both an infra transmitter and a receiver in one wall mounted unit infrared beam generated by the transmitter is back to the receiver by way of a prism mounted the opposite wall The unit monitors the reflected beam any obscuration caused by smoke If a predetermined of obscuration is reached the Fire Ray Beam Detec initiates an alarm condition by a set of alarm dry con connected to the monitoring fire alarm control panel unique design eliminates the need to run wire a transmitter and a separate remotely mounted This construction further facilitates ease of instal by making it possible for a single individual to align device versions of the Fire Ray beam smoke detector are The Fire Ray 50RU can project its beam between 15 ft The Fire Ray 100RU has a range of 160 ft 50 m to m and 160 ft 50 m ft 101 m units allow field selectable sensitivity settings of 25 or 50 obscuration unit includes a wall mounted bracket and the unit be installed either vertically or horizontally It projects beam between 1 ft 3 m and 2 ft 7 m below and par to the ceiling Lateral detection can project as wide as ft 9.1 m on either side of the beam The device is a wire detector and it is designed to operate within a range of 22 to 131 F 20 to 55 C Fire Ray Beam Detector is suitable for any open area the ceiling height exceeds 25 ft such as auditori warehouses gymnasiums etc Its compact and design makes the Fire Ray beam smoke ideal for use in shopping malls libraries hotels theaters and churches GAMEWELL FCI are for information only are not intended for installation purposes and are subject to change without notice No responsibility is assumed by Gamewell FCI for their use Clintonville Road Northford CT 06472 1610 USA Tel 203 484 7161 Fax 203 484 7118 Honeywell International Inc All rights reserved Rev C page 1 of 2 information Number Description Ray 50RU Ray Beam Smoke Detector ft to 160 ft 5m to 50m Ray 100RU Ray Beam Smoke Detector ft to 330 ft 50m to 100m Prism Reflector Continued smooth ceilings the Fire Ray beam smoke detector be spaced up to 60 ft between projected beams and more than one half that spacing between a projected and a side wall Other spacing may be used on the ceiling height the airflow characteris and the response requirements For additional infor refer to NFPA 72 the National Fire Alarm Code Range ft to 160 ft 5m to 50m Range ft to 330 ft 50m to 100m 35 or 50 to 30 VDC 10.2 30 VDC mA maximum mA maximum mA maximum Voltage Current Current Current Trouble Relay Ratings Time Time Temperature 22 F to 131 F C to 55 UL Listed installations F to 100 F 0 C to 38 C non condensing H x 4 D x 4 W H x 11.5 D x 12 D cm 1.5 lbs 0.7 kg A 30 VAC DC seconds maximum seconds maximum Humidity Ray Beam Detector Rev C page 2 of 2 Clintonville Road Northford CT 06472 1610 USA Tel 203 484 7161 Fax 203 484 7118