Gamewell-FCI Velociti® Series ATD-L2F, ATD-RL2F

Addressable Devices Series ATD L2F ATD RL2F Thermal Sensor Gamewell FCI Velociti Series addressable plug in thermal sensors with integral provide features that surpass conventional sensors Point ID allows each sensor address to be set providing exact locations for alarm locations and used for selective maintenance ATD thermal sensors an innovative thermistor sensing circuit to produce 135 fixed ATD L2F The ATD RL2F provides a combination 15 rate of with 135 fixed thermal detection that is included in a low profile package The provides fixed high temperature detection at 190 These thermal provide cost effective addressable property protection in a variety of Velociti Series uses a communication protocol that substantially increases the of communication between the sensors and Gamewell FCI analog addressable alarm controls These devices operate in a grouped fashion If one of the devices the group has a status change the panel microprocessor stops the group poll and the single device with the status change The net effect is response speed to five times greater than earlier designs ATD plug in sensors use a separate base to simplify installation service and A special tool allows maintenance personnel to plug in and remove without using a ladder the base on a box which is at least 1.5 3.8 cm deep Suitable mounting base boxes include 4.0 10.2 cm square box 3.5 8.9 cm or 4.0 10.2 cm octagonal box Single gang box except relay or isolator base B200S or B200SR base mounted on a 4.0 10.2 cm octagonal or square box B224RB or B224BI base mounted on a 3.5 8.9 cm octagonal box or a 4.0 10.2 cm octagonal or square box Due to the inherent supervision provided by the SLC the end of line resistors are not required Wiring or branches are for Style 4 Class wiring Information Addressable thermal sensor fixed 135 F Addressable thermal sensor combination fixed 135 F and 15 rate of rise Addressable thermal sensor fixed 190 F BENEFITS Sleek low profile Visual rotary switch Built in functional test activated by an magnet Bi color LEDs flash whenever the is addressed light steadily red alarm Optional relay isolator sounder bases Low standby current Addressable Stable communication with noise Optional remote LED RA 100Z Suitable for installation ducts Only the red LED operative in panels that not operate in mode Series ATD L2F ATD RL2F Technical Specifications AND HUMIDITY RANGES system meets NFPA requirements for operation at 0 49 120 and at a relative humidity 93 2 noncondensing at 32 2 90 3 the useful life of the system standby batteries the electronic components may be adversely affected extreme temperature ranges and humidity Therefore is recommended that this system and its peripherals be in an environment with a normal room of 15 27 80 ATD L2F ATD RL2F are designed to comply with the standards Standard UL 864 9th Edition LISTINGS AND APPROVALS listings and approvals apply to the modules in this document In some cases certain or applications may not be listed by certain agencies or listing may be in process factory for latest listing status S2332 3023594 FDNY 219 02 E Vol VI 7270 1703 0115 9001 Certification a complete listing of all approvals and please visit Velociti and Series are registered of Honeywell Inc is a registered trademark Underwriters Laboratories is a registered trademark Underwriters Laboratories Inc document is not intended be used for installation We try to keep our information up to and accurate We cannot all specific applications anticipate all requirements specifications are subject to without notice 2.1 5.3 cm Height 4.1 10.4 cm diameter installed in the B501 base 6.1 15.5 cm diameter installed in the B210LP base Weight 4.8 oz 137 g Temperature or ATD RL2F F to 100 F C to 38 F to 150 C to 66 Spacing approved for 50 ft 15.2 m center to center approved for 25 x 25 ft 7.6 x 7.6 m spacing Humidity 10 93 non condensing Fixed temperature setpoint 135 57 Combination 135 F fixed temperature and F 8.3 minute rate of rise Fixed temperature setpoint 190 88 Specifications Range 15 32 Volts DC peak Current mA 24 VDC without communication max avg A 24 VDC one communication every 5 seconds with LED blink enabled Current max 0065 A 24 VDC LED lit and Options Plug in sensor base without flange 4.1 10.4 cm diameter Flanged mounting base 6.1 15.5 cm diameter Flanged mounting base bulk pack 6.1 15.5 cm diameter Plug in sensor base with auxiliary relay 2 coil latching relay 1 Form C contact UL CSA 0.9 A 125 VAC inductive 0.9 110 VDC inductive 3 A 30 VDC resistive 6.1 15.5 cm diameter Plug in sensor isolator base for Style 7 operation 6.1 15.5 cm diameter 25 devices between isolator bases Intelligent sensor sounder base 6.875 17.5 cm diameter Standard sounder base UL 864 9th Edition ULC Listed 6.875 17.5 cm diameter Remote LED Annunciator Black detector covers box of 10 more information more about Gamewell FCI Veloticit Series ATD L2F and other products available by visiting Gamewell FCI Clintonville Road CT 06472 1610 F 11 17 Honeywell International Inc