Gamewell-FCI Wheelock MIZ Mini-Horn

Description MIZ Series Piezoelectric Mini are compact electronic alarm signals that are under UL 464 for Audible Appliances for use in mode Fire Protection Systems They are ideal alarm signaling in individual rooms apartments motels offices where attractive appearance performance and economical installation prime concerns MIZ Mini Horns produce high output 90 dBA at 10 feet 3.048 m with mini current draw 12 milliamperes at 24 volts All models are designed for easy installation convenient mounting on standard single gang They are ruggedly constructed of high impact and are available in either fire alarm or off white to blend with the room decor MIZ Series Strobe Horns are designed for maxi performance reliability and cost effectiveness meeting or exceeding the latest requirements NFPA 72 the National Fire Alarm Code and ANSI the American National Standard of Accessible Usable Buildings and Facilities MIZ Series signals are available for 24 VDC and be used with filtered or unfiltered full wave rec input voltages MIZ Series Signals have IN wiring terminals that accept 12 to 18 AWG wire each terminal Inputs are polarized for use on circuits Information Feet C F G 24 VDC 24 VDC C F G code suffixes R red plate W white plate descriptions of Mounting Options refer to DataSheet S7000 Use 3.5 8.89 cm deep backbox on all MIZ when EMT conduit is used Series MIZ 24 High sound output for enhanced audibility 90 dBA at 10 feet 3.048 m Low current draw with low temperature compensa tion to reduce power consumption and wiring costs 24 VDC models with wide listed voltage range filtered DC and FWR Polarized inputs for compatibility with standard reverse polarity type supervision of circuit wiring by an alarm panel Low cost installation via standard electrical boxes Attractive flush or surface mounting options No additional trim plate required for flush mounting Fast installation with In Out screw terminals for 12 to 18 AWG wire Compliance with RFI limits in FCC Part 15 Class B for compatibility with sensitive detection and com munication circuits ISO 9000 2000 Company E A p p ro v e d 5 1 9 2 E V o l II ULR of LISTED are for information only are not intended for installation purposes and are subject to change without notice No responsibility is assumed by Gamewell FCI for their use Clintonville Road Northford CT 06472 Tel 203 484 7161 Fax 203 484 7118 Rev B page 1 of 2 Gamewell FCI All rights reserved Notes Mini Horn models are Listed for indoor use with a temperature range of 32 F to 120 F 0 C to 49 and maximum humidity of 85 RH Rated input voltage either filtered DC or unfil full wave rectified FWR 24 VDC MIZ Series Signals are UL Listed over a voltage range from 20 VDC to 31 VDC Check the minimum and maximum output of the power supply and standby battery and subtract the voltage drop from the cir wiring resistance to determine the applied to the strobes UL Testing has verified that these products even at 80 of their minimum rating and of their maximum rating Cooper Wheelock recommends that the voltage applied to products be within their rated input voltage The application of improper voltage may result degraded operation or damage to these products Cooper Wheelock for installation instructions general information sheets for these products materials contain important information that be read prior to specifying or installing these including Total current required by all devices connected to system primary and secondary power sources Fuse ratings for notification appliance circuits to handle maximum inrush or peak currents from all devices on those circuits Diagram all models Do NOT loop wires use wiring Notes mounting options reference the maximum num of field wires conductors that can enter the used with each mounting option If these are exceeded there may be insufficient space the backbox to accommodate the field wires and from the wires could damage the product the limits given for each mounting option with the National Electrical Code NEC recommends the use of the larg backbox option shown and the use of approved field wires whenever possible to provide wiring room for easy installation and mini stress on the product from wiring and Engineer Specifications notification appliance shall be a Cooper Whee MIZ Series audible device or approved equiva Notification appliance shall be electronic and solid state components Electromechanical alter are not approved Each sound pressure mea at 10 feet shall be 90 dBA minimum at 24 and 88 dBA minimum at 12 VDC Operating is 24 VDC using filtered power or unfiltered supply full wave rectified All models shall provisions for standard reverse polarity type and IN OUT field wiring using terminals accept 12 to 18 AWG wiring The horn appliances may be installed indoors for surface or flush mounting They shall be mounted on standard electrical hardware requiring no addi tional trim plate or adapter products must be used within their pub specifications and must be PROPERLY specified installed operated maintained and operationally in accordance with their installation instructions at time of installation and at least twice a year or more and in accordance with local state and federal codes and laws Specification application installation maintenance and testing must be performed by personnel for proper operation in accordance with of the latest National Fire Protection Association Underwriters Laboratories UL National Electri Code NEC Occupational Safety and Health Adminis OSHA local state county province district and other applicable building and fire standards regulations laws and codes including but not to all appendices and amendments and the of the local authority having jurisdiction Rev B page 2 of 2 Clintonville Road Northford CT 06472 Tel 203 484 7161 Fax 203 484 7118