Gamewell-FCI XAL-53 Explosion-Proof Pull Station

XAL 53 Pull Station 1 XAL 53 Enclosure is made of copper free aluminum alloy Designed with conduit openings of 3 4 19.05 mm NPT Constructed of red textured powder epoxy paint finish is standard on the box and the cover and pro high visibility for the alarm station Provides universal one normally open and one normally contact furnished standard bilingual nameplates per the CSA requirement Offers an internal ground screw that is standard Spans a wiring range of 12 AWG through 24 AWG or stranded 7150 1439 0100 CE69 KILLARK XAL 53 fire alarm stations are suitable for in the following conditions Hazardous areas due to the presence of flammable or vapors combustible dusts or easily ignitable or flyings at petroleum refineries chemical and petro plants storage areas and other processing where hazardous substances are handled and Areas where emergency control of fire alarm or signal are required operate refer to the following quick easy to use two process that prevents an unintentional operation To activate the alarm station lift the front cover Then pull down the ring reset the Operator depress the shaft and return the to the original position Area Classifications Class I Division 1 and 2 Group C and D Class II Division 1 and 2 Group E F and G Class III Hazardous Locations NEMA 7CD 9EFG Block Rating 1 lists the contact block ratings 6.0 720 3.0 720 1.5 720 1.2 720 DC 1.10 0.55 0.20 1 Contact Block Ratings Data enclosure is made of cast copper free aluminum It is suitable for the following Classes Class I Groups C and D Class II Groups E F and G Class III hazardous locations installations must comply with applicable local and or Electrical Code installation DO NOT use looped wire under termi Break wire run to provide supervision of connections GAMEWELL FCI are for information only are not intended for installation purposes and are subject to change without notice No responsibility is assumed by Gamewell FCI for their use Clintonville Road Northford CT 06472 1610 USA Tel 203 484 7161 Fax 203 484 7118 by Honeywell International Inc All rights reserved www gamewell fci com Rev B page 1 of 2 Data Continued all electromechanical devices these control stations occasional maintenance Parts may wear out or defective due to the adverse environmental condi See Maintenance Data below Data you remove the cover disconnect this device from supplying circuit To prevent corrosion lubricant should be occasionally as follows Killark lubricant to box cover flanges Dow Corning Molykote 33 Grease light to operator shaft Keep all flanges clean and free of scratches Some internal service parts are available the Killark factory for the parts 1 illustrates the XAL 53 dimensions ARRANGEMENT 2 illustrates the contact arrangements ACTIVATED 3 Contact Arrangements Information Number Description station explosion proof N O and N C 2 XAL 53 Dimensions is a registered trademark of Hubbell Dow Corning and are registered trademarks of Dow Corning Corporation Rev B page 2 of 2 Clintonville Road Northford CT 06472 1610 USA Tel 203 484 7161 Fax 203 484 7118