Honeywell 5000 Series Thermostat User Manual

InSTalleR SySTem TeST 5000 Series 6000 Series begin press and hold the s and t buttons until the changes begin press and hold the s and t buttons until the changes to turn system on off to turn system on off test status test status NEXT to advance to next test DONE to terminate system test to Installer System Tests on page 8 NEXT to advance to next test DONE to terminate system test to Installer System Tests on page 8 SySTem TeSTS the system heating emergency heat cooling and fan tests vary by thermostat and system type 2 Installer System Test Type Status Number Test system 0 Description and fan off stage heat Fan turns on if Function 1 is to 1 5 9 or 10 setup Function is set to 1 stage heat stage heat and fan off and fan on stage heat heat turns on and off and on stage on system system 0 system DAMAGE HAZARD protection is bypassed during testing prevent equipment damage avoid cycling the quickly 5000 6000 Series SeTuP and TeST POckeT GuIde SeTuP 5000 Series 6000 Series begin press and hold the s and FAN buttons until display changes begin press and hold the s and FAN buttons until display changes SeTuP FuncTIOnS option and default settings vary by thermostat 1 Installer Setup functions type s or t to change settings s or t to change settings NEXT to advance to the next function DONE to exit and save settings to Installer Setup Functions on page 4 NEXT to advance to the next function DONE to exit and save settings to Installer Setup Functions on page 4 Options default in bold heat 1 cool Conv heat 1 cool heat no Aux heat only 2 wire 3 wire valves Series 20 normally open zone only with fan only heat 1 cool heat with Aux heat heat 2 cool Conv heat 1 cool Conv heat 2 cool Conv heat 2 cool heat pump Aux heat heat 2 cool heat with Aux heat valve in cooling valve in heating heat equipment heating fan furnace thermo controls heating fan or oil furnaces of than 90 or gravity water systems or fur of 90 efficiency furnaces options 1 or oil furnaces of than 90 efficiency or gravity water systems or fur of 90 efficiency furnaces options 1 or oil furnaces of than 90 efficiency or gravity water systems or fur of 90 efficiency furnaces options 1 1 Installer Setup functions Options default in bold heat rate emergency heat or gravity water systems or fur of 90 efficiency or oil furnaces of than 90 efficiency options 1 options 1 options 1 changeover changeover Heat changeover only compressor time options 0 weekdays weekends weekdays and Sunday stage cycle stage cycle Intel RecoveryTM format heat temperature stops temperature stop Max heat temperature is 90 32 options 40 to 32 Min cool temperature is 50 10 options 51 to 37 13 and 16 only available on the 6000 series 26 only available on the 5000 series valve terminal control stage heat rate stage heat rate heat rate in U S A on recycled containing at least 10 paper fibers and Control Solutions International Inc Douglas Drive North Valley MN 55422 Limited Honeywell Limit Dynamic Drive Ontario M1V 4Z9 U S Registered Trademark 2006 Honeywell International Inc Patent No 6595430 D509151 other Pending All Rights Reserved M S 09 06