Honeywell Thermostat CT51N1007 Owner’s Manual

English Page 1 Manual d de Uso Page 6 P 11 Series Mount Control Range started package contents Wall Wire Mount you begin make sure you have your old thermostat OFF POWER at heating cooling system or fuse circuit breaker panel cover and thermostat but leave wallplate with wires attached wallplate in place there a sealed tube containing mercury so see mercury notice below thermostat U S Registered Trademark Patents pending 2009 Honeywell International Inc rights reserved NOTICE your old thermostat contains contact your local waste authority for proper instructions Series Owner Manual wires and remove old wallplate a screwdriver to disconnect wires one by one As you disconnect each wire wrap it with label matching the letter on your old thermostat Adhesive labels are supplied in your package the old wallplate only after all wires are labeled Be careful not to let loose wires fall the wall opening not let wires fall into wall opening WIRE COLORS Use only letter to identify wire types If your old counting terminals C or C1 may have purchased the replacement thermostat advice If your old counting terminals C or C1 may have purchased the replacement thermostat advice mounting position Pull base Level base if Mark both screw Page 1 Fran Page 6 Espa P 11 thermostat base Drill Use hammer to tap anchors Pull and insert screws level if desired then screws wires Match on terminal Use a screwdriver to loosen screw insert bare wires beneath then tighten screws Push opening don match labels do not match letters on see table below wires Connect to RH V not use CT50 CT53 CT54 2 wire heat only system Connect one to R terminal one wire to W terminal CT51 CT55 and Rc remove the metal jumper and B if you have a pump Connect only the O with electrical tape and do not use X or B electrical tape Series Owner Manual fan operation switch CT51 CT55 or oil heating systems leave the operation switch in this factory set position systems that control the fan in a call for Change the switch to this setting for heat or electric heat systems This setting for systems that allow the thermostat to the fan in a call for heat if a fan wire is to the G terminal heat anticipator select models setting for your system table below system installation Align sides of the base then push gently the cover snaps into place Restore power at the heating cooling sys or at the fuse circuit breaker panel Page 1 Fran Page 6 Espa P 11 switch CT51 CT55 switch select models Auto cooling system is on On Heat Controls the heating system Off All systems are off Cool setting to set desired indoor temperature EQUIPMENT DAMAGE HAZARD CT51 CT55 limited warranty warrants this product to be free from defects in workmanship or materials under normal use and service If at any time during the warranty period the prod is determined to be defective or malfunctions Honeywell repair or replace it at Honeywell option the product is defective return it with a bill of sale or other dated proof of pur Care will make the determination whether the should be returned to the following address can be sent to you warranty does not cover removal or reinstallation This warranty shall not apply if it is shown by Honey that the defect or malfunction was caused by damage occurred while the product was in the possession of consumer sole responsibility shall be to repair or the product within the terms stated above of incidental or consequential damages so this limitation not apply to you limitations on how long an implied warranty lasts so above limitation may not apply to you other rights which vary from state to state you have warranty questions please write Honeywell Page 1 Manual d de Uso Page 6 P 11 CT50 la verticale