Honeywell XENON 1902 Scanner User’s Manual

Xenon 1900 1902 Scanner Guide International Inc reserves the right to make changes in speci and other information contained in this document without prior notice the reader should in all cases consult HII to determine whether any such have been made The information in this publication does not repre a commitment on the part of HII shall not be liable for technical or editorial errors or omissions contained nor for incidental or consequential damages resulting from the furnish performance or use of this material document contains proprietary information that is protected by copyright rights are reserved No part of this document may be photocopied repro or translated into another language without the prior written consent of 2010 2011 Honeywell International Inc All rights reserved product names or marks mentioned in this document may be trademarks registered trademarks of other companies and are the property of their owners Address www honeywellaidc com Windows Windows NT Windows 2000 Windows ME Windows and the Windows logo are trademarks or registered trademarks of Microsoft Bluetooth word mark and logos are owned by Bluetooth SIG Inc product names or marks mentioned in this document may be trademarks registered trademarks of other companies and are the property of their owners Agency Compliance Xenon 1900 Part 15 Subpart B Class B device complies with part 15 of the FCC Rules Operation is subject to following two conditions This device may not cause harmful interference This device must accept any interference received including that may cause undesired operation equipment has been tested and found to comply with the limits for a B digital device pursuant to part 15 of the FCC Rules These limits designed to provide reasonable protection against harmful interference a residential installation This equipment generates uses and can radi radio frequency energy and if not installed and used in accordance the instructions may cause harmful interference to radio communica However there is no guarantee that interference will not occur in a installation If this equipment does cause harmful interference to or television reception which can be determined by turning the equip off and on the user is encouraged to try to correct the interference by or more of the following measures Reorient or relocate the receiving antenna Connect the equipment into an outlet on a circuit different from that to the separation between the equipment and receiver the receiver is connected Consult the dealer or an experienced radio or television technician for necessary the user should consult the dealer or an experienced radio technician for additional suggestions The user may find the fol booklet helpful About Interference This is available at local regional offices Honeywell is not responsible for any radio or interference caused by unauthorized modifications of this equip or the substitution or attachment of connecting cables and equipment than those specified by Honeywell The correction is the responsibil of the user only shielded data cables with this system This unit has been tested cables less than 3 meters Cables greater than 3 meters may not meet B performance Any changes or modifications made to this equipment not approved by Honeywell may void the FCC authorization to oper this equipment Statement listed UL60950 1 Canada ICES 003 Class B digital apparatus complies with Canadian ICES 003 Opera is subject to the following conditions This device may not cause harmful interference This device must accept any interference received including that may cause undesired operation la r canadienne appareil num de la Classe A est conforme la norme NMB 003 Canada Son fonctionnement est assujetti aux conditions suivantes Cet appareil ne doit pas causer de brouillage pr Cet appareil doit pouvoir accepter tout brouillage re y compris le pouvant causer un fonctionnement ind Statement cUL listed CSA C22.2 No 60950 1 07 CE marking indicates compliance to 2004 108 EC EMC Directive Standards EN55022 CLASS B EN55024 EN61000 3 2 In addition complies to 2006 95 EC Low Voltage Direc when shipped with recommended power supply further information please contact Imaging Mobility Europe BV 9 13 BT Eindhoven Netherlands International Inc shall not be liable for use of our product with i e power supplies personal computers etc that is not CE and does not comply with the Low Voltage Directive Electrical and Electronic Equipment complies with Directive 2002 96 EC OF THE EUROPEAN PAR AND OF THE COUNCIL of 27 January 2003 on waste electrical electronic equipment WEEE product has required the extraction and use of natural resources for its It may contain hazardous substances that could impact health the environment if not properly disposed order to avoid the dissemination of those substances in our environment to diminish the pressure on the natural resources we encourage you to the appropriate take back systems for product disposal Those sys will reuse or recycle most of the materials of the product you are dis in a sound way crossed out wheeled bin symbol informs you that the product not be disposed of along with municipal waste and invites you to the appropriate separate take back systems for product disposal you need more information on the collection reuse and recycling sys please contact your local or regional waste administration may also contact your supplier for more information on the environ performances of this product your product is marked with the GS symbol then the product been issued a GS certificate showing compliance to EN Second Edition Statement to AS NZS 3548 EMC requirement Conforms to NOM 019 certificate Korea product meets Korean agency approval the following label is attached to your product the product meets Taiwan approval Standard CNS13438 CNS14336 CNS13438 CNS14336 Safety Statement have been tested and classified as RISK GROUP to the IEC 62471 2006 Scheme to CB Scheme IEC 60950 1 Second Edition Safety Statement the following label is attached to your product it indicates the product a laser engine or laser aimer LIGHT DO NOT STARE INTO BEAM 2 LASER PRODUCT mW MAX OUTPUT 650nM 60825 1 Ed 2 2007 with 21 CFR 1040.10 and 1040.11 for deviations pursuant to Laser No 50 dated June 24 2007 device has been tested in accordance with and complies with ed2.0 and 21 CFR 1040.10 and 1040.11 except for deviations to Laser Notice No 50 dated June 24 2007 LIGHT DO NOT STARE INTO BEAM CLASS 2 LASER PROD 1.0 mW MAX OUTPUT 630 650nM use of controls or adjustments or performance of procedures than those specified herein may result in hazardous radiation expo patent information please refer to www honeywellaidc com patents and Water Protection Xenon 1900 has a rating of IP41 immunity of foreign particles and dripping reduce the possibility of heat related injuries avoid touching sec of the scanner that feel warm Agency Compliance Xenon 1902 and Base Part 15 Subpart C device complies with part 15 of the FCC Rules Operation is subject the following two conditions This device may not cause harmful interference This device must accept any interference received including that may cause undesired operation changes or modifications made to this equipment not approved by Honeywell may void the FCC to operate this equipment only shielded data cables with this system This unit has been tested cables less than 3 meters Cables greater than 3 meters may not meet B performance Statement listed UL60950 1 Canada device complies with Canadian RSS 210 Operation is subject to the conditions This device may not cause interference This device must accept any interference including interference that cause und