Invensys MSC-UC-PMF Pneu Manifold Assem

ENVIRONMENTAL 16 Unit Controller Filter assembly distributes MSC UC PMF Manifold air to the MSC UC PO MicroSmart Unit Controller Output card which can be used with the DCM UC or the MSC UlOOO The MSC UC also provides an intermediate connection the lines An air filter is provided for removing dirt and other debris that may accumulate the air line are the MicroSmart Unit with these Filter and Pneumatic Manifold Assembly package of hardware the single or its installation enclosure which will also house the MicroSmart Unit installation process for the MSC beginning visually inspect the unit for any obvious defects to make sure all parts are included any flaws are contact your local Robertshaw office or One Nl OO 690061 One N406 253 Guide bag that includes the terminal strip 1 01 pressure gauge 1 main air manifold 26 l 8 elbow 1 OO 2530 3 8 elbow 1 OO 2356 6 OO 250015 union 1 KEP nuts 11 1 pneumatic The MSC UC PMF MSC UC PO connection an on the unit controller The MSC UC PMF no electrical power a pneumatic device and in single ENC 001 or dual ENC 002 with the associated unit controller Complete and installation are provided on following page to install the Pneumatic refer to the illustrations on the following pages follow these Assembly items from the hardware package the tubing terminal strip over the two screws the gauge tee over the two screws at the of the bracket with the open end of the tee the interior of the enclosure and the tubing pointing toward the top of the enclosure assembly mounts on the enclosure the top of the backplate place with two nuts 1 y Figures 2 and 3 Tighten with nuts manifold has nine terminals These sealed and the installer must drill out those a particular application Use a l l 6 bit over terminals assembly on a flat surface available Drill carefully so that only the flashing through thin Before drilling place in a vise if one drilling remove any plastic particles the manifold Eight of the terminals may be for output tubing and one may be used for the air gauge Fit the black elbow tightening with the barbed end pointing direction as the manifold the open end of the manifold the Slip the main air manifold with elbow over the studs and secure with nuts The manifold should face the rear of the enclosure Connect brass elbow to main air gauge Use pipe to seal Filter should be replaced Part number RMSC UC PMF and or the easy it becomes element a filter O D AIR loo 2530 OO 250018 CONNECTOR loo 2356 TUBING OO 250016 OO 250017 UNION loo 2356 TUBING loo 2502 SIDE SIDE