Kidde 3101094-EN R04 SA-CLA Class A Interface Card Installation Sheet

Class A Interface Card Sheet SA CLA card allows NAC Class A wiring of the 64 point control The card s terminal block provides the wiring connection for the Class A return SA CLA also contains circuitry that enables the CH1 and CH2 circuit on the panel This allows you to connect a Class B remote annunciator circuit to the panel Refer to the technical reference document for details Class A card is installed directly onto the control panel circuit using plastic standoffs and a plug connector install the Class A card Power down the panel and disconnect the batteries Locate connector J2 at the bottom right of the main circuit board Connect the card to connector J2 as shown in the diagram below sure you properly align the connector pins and plastic standoffs Connect the field wiring See below Power up the panel and connect the batteries 1 SA CLA installation 2 SA CLA wiring TB2 on main circuit board SA CLA installed on main board voltage current resistance capacitance current rating fault impedance 0 to 5 k environment humidity VDC 3 mA 60 mA A per circuit to 18 AWG 0.75 to 2.5 mm2 to 120 0 to 49 to 93 noncondensing at 90 32 information contact information see www edwardsfiresafety com 2015 Walter Kidde Portable Equipment Inc rights reserved Connector J2 Bottom right of main circuit Plastic mounting standoffs SA CLA card wiring connections on the Class A card are used when wiring Class A 3101094 EN REV 04 ISS 18DEC15 2 2 3101094 EN REV 04 ISS 18DEC15