Mircom CAT-5345 - UDACT-300A - Digital Alarm Communicator Dialer

DIGITAL ALARM COMMUNICATOR DIALER MODULE Communicates with Mircom FA 1000 FX 2000 or FleX Series alarm control panels via an RS 485 data link Programmed to use the Ademco Contact ID and SIA DCS protocols Can be con for DACT or UDACT mode of operation DACT mode transmits a common Alarm Supervisory and Trouble information UDACT mode transmits point specific Alarm Supervisory and Trouble information ZDACT feature allows for input circuits on the FX 2000 FleX Net panel to be grouped into software zones so the UDACT 300A will report any individual event as group event Reports either the circuit number or the combination of number and address when used with the FX 2000 FleX Net Series Event number offset for output circuit numbers provides the for each circuit on an FX 2000 or FleX Net Series to have a unique circuit number transmitted to the station Override feature allows for the device type to be changed the standard input type on the FX 2000 or FleX Net panel to a pre de input type that is sent to the station UDACT 300A has the ability of disconnecting the incoming outgoing calls and capturing the line for transmission the Digital Alarm Communicator Receiver DACR Onsite or remote programming Onsite con with the on board keypad and the CFG Con Tool or using the UIMA Programming and a computer with an available serial or USB port Remotely con via a Personal Computer with a Con is passcode protected Provides telephone line monitoring and reports status via indication on board Provides event logs of 500 entries each to save events local dialer or remote alarm panel can be reviewed locally with the CFG 300 Tool or remotely via modem Continuously supervises the status of each of two telephone lines at approximately one minute Mounts in a dedicated location in the FA 1000 FX 2000 FleX Net Series main chassis NUMBER UDACT 300A Digital Alarm Communicator Transmitter Module allows Mircom FA 1000 FX 2000 or FleX Net Fire Alarm Control Panels to transmit Alarm Supervisory Trouble information on two telephone lines to a monitoring UDACT 300A is powered by the host alarm control and communicates with the alarm control panel an RS 485 data link The Digital Communicator can be for dual line operation and uses the Security Association SIA and Ademco Contact ID reporting UDACT 300A can be con locally via the on board and the CFG 300 Con Tool or with a UIMA tool and a computer with an available serial USB port In addition the UDACT 300A can be remotely using a personal computer with a modem UDACT 300A can be con for either DACT or operation In DACT mode the Digital Communicator common alarm trouble and supervisory information In mode the Digital Communicator reports point speci In addition the UDACT 300A is equpped with the feature that allows for input circuits on the FX 2000 FleX Net panel to be grouped into software zones for the of reporting to a central monitoring station TO BE USED FOR INSTALLATION PURPOSES INFORMATION IS FOR MARKETING PURPOSES ONLY AND INTENDED TO DESCRIBE THE PRODUCTS TECHNICALLY Connection Diagram Configuration Tool CFG 300 Configuration Tool is required for onsite of the UDACT 300A The CFG 300 plugs into UDACT 300A to provide a two line by 20 character LCD The CFG 300 tool is used for configuration purposes and not for normal operation Consumption mA mA Wiring Diagram cable to FA 1000 FX 2000 Series alarm control holes Information Digital Alarm Communicator Transmitter Tool Programming Tool Interchange Way Ontario L4K 5W3 905 660 4655 905 660 4113 Witmer Industrial Estates Falls NY 14305 Free 888 660 4655 Toll Free 888 660 4113 INFORMATION IS FOR MARKETING PURPOSES AND NOT TO DESCRIBE THE TECHNICALLY complete and accurate installation testing and certification refer to technical This document contains intellectual property of Mircom information is subject to change by Mircom without notice does not represent or warrant correctness or completeness relating 5345 0