Mircom CAT-5948 MIX-2251RAP Intelligent Photoelectric Smoke Sensors for Duct Applications (English)

INTELLIGENT SMOKE SENSOR WITH REMOTE TEST MIX 2251RAP Sleek low profile design Photoelectric technology Remote test capability in duct applications Dual LEDs indicate communications and activate steady in alarm Low profile base provides easy interchangeability Low standby current Rotary switches for direct dial entry of address Magnetic test feature Tamper Resistance a plug in Intelligent Photoelectric Smoke Sensor remote test capability in Duct Applications MIX 2251RAP smoke sensor combines a photoelectronic sensing chamber with communications The sensor transmits an representation of smoke density over a communication to a control panel Rotary switches are provided for setting sensor address LEDs on the sensor are controlled by the panel it indicate status An output is provided for connection to an remote LED annunciator MIX 2251RAP is used in duct applications with a testing can be done remotely using approved test eliminating the need for a test coil MIX 2251RAP compatible addressable to function properly Connect to a compatible panel only MIX 2251RAP includes a tamper resistant capability that its removal from the bracket without the use of a tool MIX 2251RAP sensor mounted in a B210LP base low profile intelligent plug in smoke detectors integral communications provide features that surpass detectors Sensitivity is continuously monitored reported to the panel where the desired detector can be programmed Point ID capability allows each address to be set with decade address switches exact detector locations for selective maintenance chamber contamination reaches an unacceptable level Advanced Protocol AP devices use a high speed protocol that greatly increases the speed of between the intelligent devices Mircom Protocol uses a superior group polling method as as an interrupt feature that provide for a faster response to alarm condition In addition the Advanced Protocol allows greater system capacity with support for up to 318 devices SLC circuit The AP devices are backwards compatible to in CLIP mode for legacy system applications TO BE USED FOR INSTALLATION PURPOSES INFORMATION IS FOR MARKETING PURPOSES ONLY AND INTENDED TO DESCRIBE THE PRODUCTS TECHNICALLY NUMBER Range to 32 VDC Current uA 24 VDC one communication every 5 sec with blink enabled Current max mA 24 VDC on inches 51 mm installed in B210LP Base inches 155 mm installed in B210LP Base inches 104 mm installed in B501 Base Weight oz 147 g Humidity Range 93 non condensing Temperature Range 32 to 120 0 to 49 Applications 4 to 158 20 to 70 Listed Velocity Range Velocity 0 4000 fpm Photoelectric Smoke Sensor with Remote Test Capability for Duct Applications Information suffix for ULC listed model Flangeless Mounting Base Flanged Mounting Base LED Annunciator Interchange Way Ontario L4K 5W3 905 660 4655 905 660 4113 Witmer Industrial Estates Falls NY 14305 Free 888 660 4655 Toll Free 888 660 4113 INFORMATION IS FOR MARKETING PURPOSES AND NOT TO DESCRIBE THE TECHNICALLY complete and accurate installation testing and certification refer to technical This document contains intellectual property of Mircom information is subject to change by Mircom without notice does not represent or warrant correctness or completeness relating 5948 0