Mircom Fire-Link3 Sell sheet

F EXTENSION FOR EMERGENCY FIRE ALARM SYSTEMS Fire Link3 offers a fast clean and cost effective fire alarm audible signaling solution for multi buildings that are in need of a fire alarm upgrade In addition Fire Link3 is a wireless solution that installs new fire alarm output strobes horns etc without the need to add to the building Fire Link3 is the perfect retrofit communications is accomplished wirelessly an extremely robust and secure mesh network The two main system components are the Controller ZC and the Wireless Input Output unit The Zone Controllers can be daisy chained and one per floor in the building Zone Controllers be connected using either addressable loops or bell circuits to the Fire Panel Wireless Input Output Unit is a wireless base and is to be connected to Mircom and other third notification appliances with Mircom fire control panels FleX Net FX 2000 FX 3500 FX 4000N FX 400 401 and Secutron MMX and MR 3318 that have addressable SLC using addressable devices in CLIP mode only to any fire alarm control panel with contacts Wireless connection to notification devices Up to per Zone Controller ZC backup Single and Two stage notification Trouble AC Fail and Alarm relay UL 864 ULC S527 Listed Diagram Wireless base unit Connection Connection Strobe Strobe Strobe Strobe Controller Alarm Control Panel Zone Controller ZC Zone Controller ZC manages the wired connection the FACP Fire Alarm Control Panel and the wireless with the Wireless Input Output Units The ZC into a dedicated branch 120 240 VAC receptacle Zone Controller relays messages between the Wireless Units and the Fire Alarm Control Panel It plugs any 120 240 VAC receptacle has battery backup Zone should be installed one per floor or zone and through either the Notification appliance Circuit NAC or Loop SLC connection to the Fire Alarm Control The Zone Controller is not an annunciator Frequency 2.4 GHz number of Zone Controllers per system 16 with the ZC 301W is Black back box Main board Inner chassis Front door WIO Wireless Input Output unit Wireless Input Output unit is a wireless device that the notification appliance to the Zone Controller The Wireless unit communicates with the Zone Controller and drives one notification Supported notification appliances are the following 2 wire notificationappliances manufactured by Mircom two stage is not supported System Sensor and Wireless Input Output units is powered by 120 or 240 VAC has a backup battery Frequency 2.4 GHz number of Wireless Input Output units per Zone is 49 number of Wireless Input Output units per system 784 contents of this document may be changed by Mircom Technologies Ltd without notice Mircom makes no representations or about the completeness or accuracy of these contents and expressly disclaims liability howsoever arising therefrom These including all referenced trade names logos graphics marks and copy right information registered or unregistered are the property of Mircom and shall not without its prior consent be used reproduced stored or transmitted by any means Purchase Mircom products is subject to standard warranties software license agreement and terms and conditions available on request 2018 All rights reserved Exclusive property of Mircom Technologies Ltd more information call visit Mircom com 4 1 22