Mircom I56-3314 MIX-M500MAP (English)

25 Interchange Way Vaughan Ontario L4K 5W3 905.660.4655 Fax 905.660.4113 AND MAINTENANCE INSTRUCTIONS Monitor Module Operating Voltage Alarm Current LED on Operating Current Resistance IDC wiring resistance IDC Voltage IDC Current Range to 32 VDC LED on 1 communication every 5 seconds 47k EOL Ohms Ohms Volts to 120 0 to 49 to 93 Non condensing H x 4 W x 11 4 D Mounts to a 4 square by 21 8 deep box Electrical Box INSTALLINg information is included as a quick reference installation guide Refer to control panel installation manual for detailed system information If the will be installed in an existing operational system inform the opera and local authority that the system will be temporarily out of service Dis power to the control panel before installing the modules This manual should be left with the owner user of this equipment DESCRIPTION MIX M500MAP Monitor Module is intended for use in intelligent two systems where the individual address of each module is selected using built in rotary decade switches It provides either a 2 wire or 4 wire fault initiating circuit for normally open contact fire alarm supervisory or devices The module has a panel controlled LED indicator REqUIREMENTS ensure proper operation these modules shall be connected to listed com system control panels only 1 CONTROLS AND INDICATORS MIX M500MAP mounts directly to 4 inch square electrical boxes see 2 The box must have a minimum depth of 21 8 inches Surface electrical boxes SMB500 are available from System Sensor 2 MODULE MOUNTINg All wiring must conform to applicable local codes ordinances and This module is intended for power limited wiring only Install module wiring in accordance with the job drawings and appropri wiring diagrams Set the address on the module per job drawings Secure module to electrical box supplied by installer as shown in Fig 2 Mircom 3 TyPICAL 2 WIRE INITIATINg CIRCUIT CONfIgURATION NfPA STyLE B NEXT NUMBER OF UL LISTED CLOSURE DEVICES BE USED DO NOT MIX FIRE INITIATING OR SECURITY ON THE SAME MODULE PANEL OR DEVICE MODULES TO LISTED CONTROL PANELS ONLY EOL DEVICE CIRCUIT IDC NFPA STYLE B LIMITED 400 MAX 11 VDC MAX CONTACT CLOSURE DEVICES PER INSTALLATION INSTRUCTIONS LINE CIRCUIT SLC VDC MAX PAIR RECOMMENDED WIRING SHOWN IS SUPERVISED AND POWER LIMITED 4 TyPICAL 4 WIRE fAULT TOLERANT INITIATINg CIRCUIT CONfIgURATION NfPA STyLE D NEXT NUMBER OF UL LISTED CLOSURE DEVICES BE USED DO NOT MIX FIRE INITIATING OR SECURITY ON THE SAME MODULE RESISTOR INTERNAL AT AND 9 PANEL OR DEVICE MODULES TO LISTED CONTROL PANELS ONLY LINE CIRCUIT SLC VDC MAX PAIR RECOMMENDED CONTACT CLOSURE DEVICES PER INSTALLATION INSTRUCTIONS WIRING SHOWN IS SUPERVISED AND POWER LIMITED Mircom