Mircom LT-6212 WR-3001W Installation Manual

WR 3001W Wireless Input Output Unit Installation Force installation or excessive force will damage the motherboard and being installed or removed Sensitive Components AC and Battery power is disconnected before installing or removing boards modules or cables 3 circuit boards contain static sensitive components Operators always be grounded with a proper wrist strap before handling any to remove any static charges from the body Use static suppressive to protect electronic assemblies and operators should use proper conduit and wire isolation to keep and other wiring at least 1 4 inches apart the WIO Unit Wireless Input Output unit mounting plate is compatible with 3 by 2 single gang device boxes 3 3 4 by double gang boxes 4 by 2 single gang utility boxes standard 4 by 4 boxes and standard 4 octagon needed Hexnut driver Precision or jeweler s screwdriver set Philips screwdriver Wire cutter Wire Tips visual inspection of parts for obvious issues the incoming wires through the top of the enclosure Use a wire tie to group wires for easy and neatness Rev 0 Nov 2021 Wireless Input Output Unit WIO Installation and Dimensions Screw with bit 5 8 mm 3 4 mm Plate Input Output 1 Parts of the Wireless Input Output unit the Wireless Input Output unit Wireless Input Output unit may be mounted on the wall or ceiling connect the AC power the mounting plate to the standard 120 VAC or 240 VAC service with three wires or 240 VAC 2 Mounting Plate Front View Wireless Input Output Unit WIO Installation Mount the Mounting Plate Mount the mounting plate with the arrow pointing up see Figure 2 Attach the mounting plate to the gang box with 2 or 4 screws side up 3 Mounting Plate Back View Snap the Wireless Input Output unit onto the mounting plate and secure with the screw 4 Mounting the Wireless Input Output unit on the Mounting Plate Wireless Input Output Unit WIO Installation Switches must configure each Wireless Input Output unit with both a PAN ID and channel ID all Wireless Input Output units on the same floor or zone set the channel ID and PAN ID to the same ID and PAN ID as the Zone Controller for that floor or zone All devices in the same zone should have same channel ID and PAN ID Refer to LT 6210 Fire Link 3 Manual for DIP switch settings USB port configuration switches for ID and ID for Circuit included jumper wire battery to 5 of Wireless Input Output unit DIP Switches and Connections Appliance Wiring notification appliance as show in Figure 6 please refer to LT 6210 Fire Link 3 Manual for complete screw separation of mounts 11 16 Appliance Notification Plate Mounting Plate CLASS B wires to allo of applian WIO without wires wires to allow of notification to WIO without wires 6 Wiring the Notification Appliance Mounting Plate to WIO unit