Mircom MIX-4030 MIX-4030-ISO Tri-Mode Heat Detector Data Sheet (English)

TRI MODE HEAT DETECTOR MIX 4030 ISO Any combination of MIX 4000 series devices up to 240 be connected on a single SLC Different LED colors for Alarms and Troubles Three operational modes of heat detection Compatible with the full series of MIX 4000 input and modules The device can be secured by a unique Anti Tamper The address is set with the hand held device programmer MODEL OPTION Built in short circuit isolator MIX 4030 Operating Modes Rate of rise heat detection 135 Fixed heat detection 135 Fixed heat detection 175 Open style mounting bases offer easy wiring and low locking 4 or 6 base options available Remote output can be controlled by the panel MIX 4030 ISO is equipped with a bi directional short isolator to protect against wiring faults and loop Low standby current Base has detachable tab for labeling device address Leverages interrupts to quickly report alarm conditions to alarm control panels Magnet test option helps with commissioning and MIX 4030 ISO MIX 4030 MIX 4030 ISO detector is a hardwired sensor continuously monitors the environmental temperature to high heat conditions and communicates with the panel a fully digital protocol alarm will be reported when the sampled temperature 135 57 or 175 79 depending on the mode of operation Excessive temperature rises also be reported if the detector is configured for rate operation MIX 4030 MIX 4030 ISO works with an MGC compatible panel supporting high rates of information exchange reliable and secure bi directional communication detector is addressed and programmed using the hand held device Addresses can be selected from range of 1 240 detector ships with a dust cover to protect the device installation and prior to commissioning tri color LEDs on the device provide 360 degrees of visibility remote LED indicator can be wired directly to the sensor TO BE USED FOR INSTALLATION PURPOSES INFORMATION IS FOR MARKETING PURPOSES ONLY AND INTENDED TO DESCRIBE THE PRODUCTS TECHNICALLY NUMBER Specifications Operating Voltage 15 to 30VDC Alarm Current Current Range range on terminals LED on to 100 0 to 37.8 to 93 Non condensing to 12 AWG LED colors Steady on Flash Steady on condition condition condition Detection Settings 57 79 57 rate of rise Information Smoke Detector Non Isolated Smoke Detector with short circuit isolator Non Isolated with built in short circuit isolator Detector Non Isolated Detector with built in short circuit isolator Addressable Device Programmer Detector Base Detector Base Interchange Way Ontario L4K 5W3 905 660 4655 905 660 4113 Witmer Industrial Estates Falls NY 14305 Free 888 660 4655 Toll Free 888 660 4113 INFORMATION IS FOR MARKETING PURPOSES AND NOT TO DESCRIBE THE TECHNICALLY complete and accurate installation testing and certification refer to technical This document contains intellectual property of Mircom information is subject to change by Mircom without notice does not represent or warrant correctness or completeness relating 9503 3