Potter FHA Addressable Fixed Temperature Heat Detector

Features Software adjustable 135 Fahrenheit heat sensor Low profile Reliable detection technology LEDs for 360 viewing Ambient temperature listing of 32 F to 150 F 7165 0328 0193 includes a 5 year warranty Fixed Temperature Heat Sensor FHA is a listed Analog fixed temperature heat sensor compatible with any fire control panel that has the Potter Nohmi protocol The heat portion utilizes a proven thermistor for accurate and reliable detection The sensor and base not included are made of a plastic in an eggshell white to blend in with the ceiling FHA is UL and cUL listed with a selectable fixed temperature from 135 to 185 Fahrenheit This broad range allows the to cover a wide variety of applications with a single unit FHA has two LEDs that allow for 360 viewing The sensor is with any of the Potter Nohmi bases The FHA is addressed the hand held programmer or the control panel addressing FHA spacing is dependent on the alarm set point The unit is from 135 to 185 as the temperature setting increases the spacing decreases set point to 170 57 to 76 to 174 77 to 79 to 185 80 to 85 Spacing Max 50 ft 15 ft 15 ft system has a maximum of 13 LEDs that can be turned on simul If the system already has 13 LEDs on the FHA will operate though the LED will not illuminate the Address addressable module smoke sensor heat detector and sensor detector must have the address set before the device to the SLC loop The address is set using the held device programmer or the addressing feature on the control connecting a device to the SLC loop take the following to prevent potential damage to SLC or device Verify the to the device is removed wiring is correctly installed wiring has no open or short circuits discrepancies and notify appropriate personnel to 24.0 V voltage range current LEDs indicator mA D C indicator current set point range to 185 57 to 85 temperature range 32 to 150 0 to 66 relative humidity time number of per loop number of lighted in alarm per zone without base without base 1 sec to 93 Non condensing White 2.57oz 1.50 in 38mm 4.0 inches 99mm cUL CSFM Listings Electric Signal Company LLC St Louis MO Cust Service 866 240 1870 Tech Support 866 956 1211 Canada 888 882 1833 www pottersignal com 1 OF 2 8830017 REV C06 13PRINTED IN USAFhAFixed TemperATure heAT SenSor firealarmresources com FHA is an analog addressable sensor that uses one address on the Signaling Line Circuit SLC of a compatible fire alarm control panel The communicates with the control panel as it is polled The LEDs flash every time the unit is polled and they will latch steady if the unit is in active status FHA is a single sensor that may be used in a wide variety of applications for property protection The FHA has a high ambient installation and has been tested in these environments The unit has a sleek design and low profile for pleasing aesthetics The temperature is protected within the mold of the unit to prevent accidental damage Bases bases will mount on a single gang double gang octagon 4 square or mud ring electrical box Standard Base Standard Base base with an isolator module included The base is pre wired with a pluggable jumper to the module base with a dual relay module included One relay is rated for 8 amps at 240 VAC 30 VDC and the second is for 2 amps at 240 VAC 30 VDC The base is pre wired with a pluggable jumper to the module base with sounder module included Sound pattern is provided from external source The base is pre wired a pluggable jumper into the module 2 OF 2 8830017 REV C06 13PRINTED IN USAFhAFixed TemperATure heAT SenSor firealarmresources com