Potter SCM24W-75110 SELECT-A-STROBE CHIME COMBINATION

A Brand Meets or exceeds NFPA ANSI Standards and ADA Accessability Guidelines UL Listed for wall mounting Screw terminal capacity up to AWG 12 Universal mounting plate included Selectable settings 75cd or 110cd Polarized strobes with wide operating voltage range using ltered DC or un ltered FWR input voltage Horn eld selectable tones Hz or 2400 Hz or Non temporal or Low dBA Output Mounts to 4 square single gang double gang or octagonal back box Tamper proof candela selector switch Synchronization requires Sync Module SMD10 3A Available in red or white housing Select A Strobe Chime Series is designed to provide audible private mode for re alarm protection systems It complies with ADA meets or exceeds NFPA ANSI audible emergency evacuation signal and UL 464 private mode 1971 The SCM24W Series features a candela intensity eld selector switch for alternating the candela output 75cd to 110cd The chime provides two different eld selectable and a high low output setting that can be achieved with the use of mini jumpers located on the back of the unit These appliances are for connecting to supervised re alarm circuits The strobe is designed with a xenon ash tube and provides a candela intensity eld switch for maximum performance SCM24W 75110 can be synchronized by using the SMD10 3A Sync Module to comply with NFPA recommendations concerning epilepsy when installing two or more visual appliances within the eld of view The strobe signals are listed for indoor use wall under UL1971 standard Information Number Out cd 4580012 White DC VDC VFWR or 110 Terminals 120 49 Speci cations audible and visual alarm indicating appliances shall be Amseco model SCM24W 75110 or equivalent device The chime shall be listed UL 1971 Standard for signaling devices for the hearing impaired and shall be approved for re protective service The candela output be eld selectable having a dual setting of 75cd or 110cd output The chime shall provide two different eld selectable temporal or steady and a high low eld selectable output setting The signaling strobe shall operate on a 24V DC non coded regulated DC supply or full recti ed un ltered supply The chime may operate on a 24V DC coded system The strobe shall be designed to produce one signal ash second with continuously applied minimum voltage The strobe chime shall have a universal back mounting plate capable of wall mounting a back box When strobe synchronization is required the strobe chime shall be compatible with Amseco SMD10 3A daisy chain or other of Amseco sync protocol Audible and visual signaling devices shall be installed in accordance with current NFPA guidelines Electric Signal Company 2081 Craig Road St Louis MO 63146 4161 Phone 800 325 3936 Canada 888 882 1833 www pottersignal com IN USA 8850026 REV A 1 OF 2 Brand Gang Box Square Back Box Gang Box Mounting Plate Output Light RMS operating Current mA FWR DC Hz Hz of SCM24W must be used only on circuits with continuously operating DO NOT use strobe on coded or interrupted circuits in the applied voltage is interrupted ON and OFF as the strobe fail to ash The applied voltage must be within its rated input range Fuse ratings on signaling circuits must handle peak from all devices connected to those circuits IN USA MKT 8850026 REV A 2 OF 2