Radionics - D2812 Installation Manual

D2812 Control Communicator Manual P N 33120C 1997 Radionics material and instructions covered in this manual have been checked for accuracy and are presumed to be reliable Radionics Inc assumes no responsibility for inaccura and reserves the right to modify and revise this manual notice telephone company may make changes in its facilities operations or procedures that could affect the of the D2812 If this happens the telephone company provide advance notice in order for you to make the necessary to maintain uninterrupted service a discrepancy is found in this documentation please mail a of the corrected material to Communications Radionics Inc Abbott Street Box 80012 CA 93912 0012 1997 Radionics Inc Salinas CA U S A All rights reserved Notice 15 equipment has been tested and found to comply with the for a Class B digital device pursuant to Part 15 of the FCC These limits are designed to provide reasonable protection harmful interference in a residential installation This generates uses and can radiate radio frequency and if not installed and used in accordance with the manual may cause harmful interference to radio However there is no guarantee that interference not occur in a particular installation If this equipment does harmful interference to radio or television reception which be determined by turning the equipment off and on the user encouraged to try to correct the interference by one or more of following measures Re orient or relocate the receiving antenna Increase the separation between the equipment and the Connect the equipment into an outlet on a circuit different from to which the receiver is connected Consult the dealer or an experienced radio TV technician for 68 equipment complies with Part 68 of FCC rules A label among other information the FCC registration number ringer equivalence number REN registered the D2812 Control Communicator for to the public telephone network using an RJ31X jack the ringer equivalence number REN to determine the of devices you can connect to the telephone line RENs on the telephone line may result in devices not in response to an incoming call In most but not all areas sum of the RENs should not exceed five 5 Contact the company to determine the maximum REN for the area the D2812 Control Communicator causes harm to the telephone the telephone company will notify you in advance If notice isn cid 146 t practical the telephone company will notify customer as soon as possible Also you will be advised of right to file a complaint with the FCC if you believe it is you experience trouble with the D2812 Control Communicator contact Radionics Customer Service for repair and or information If the trouble is causing harm to the network the telephone company may request that you the D2812 from the network until the problem is resolved repairs must not be made Doing so voids the user cid 146 s not install the D2812 on public coin service provided by the company Connection to Party Line service is subject to tariffs contact your state public utilities commission for You must supply the local telephone company with following information at their request The line you are going to connect the panel to Make Radionics model D2812 and serial number of the FCC registration number and ringer equivalence for the Registration Number ESVUSA 30727 AL E Equivalence 0.3B Center in USA Radionics Inc Abbot Street Box 80012 CA 93912 0012 538 5807 Industry Canada label identifies certified equipment This means that the equipment meets certain telecommu network protective operational and safety require Industry Canada does not guarantee the equipment will to the user cid 146 s satisfaction installing this equipment users should ensure that it is to be connected to the facilities of the local telecom company The equipment must also be installed using acceptable method of connection The customer should be that compliance with the above conditions may not prevent of service in some situations to certified equipment should be made by an authorized maintenance facility designated by the supplier Any or alterations made by the user to this equipment or malfunctions may give the telecommunications cause to request the user to disconnect the equipment should ensure for their own protection that the electrical connections of the power utility telephone lines and metallic water pipe system if present are connected Users should not attempt to make such connections but should contact the appropriate electric inspection or electrician as appropriate P N 33120C 1997 Radionics Installation Manual 2 Of Contents 4 the Telephone Connections 10 Control Communicator 4 Separately 4 Options 4 and Approvals 5 Started 5 the Enclosure 5 the Premises Wiring 5 to Earth Ground 6 6 6 the Battery as You Work 6 the Standby Switch 6 Detection Devices Keypads Bells 6 Connection to the Panel Yet 6 of Sensors 6 Connections to the Panel 7 Down First 7 Output 7 7 Power 8 Continuous Current Draw 8 Relays 8 the Points 8 1 8 2 to 6 9 Wiring Diagram 9 Expanders Wired or RF 10 Up 10 the Panel 10 the Standby Switch 10 out the Delay Chart 11 the System 11 Description 11 AC Power Circuit 11 DC Power 11 Outputs 12 12 13 13 Diagram 14 Guide for UL Applications 15 15 Compatible Equipment 15 Chart 17 Rating Chart for Standby Battery 18 Battery Requirements 17 Wiring Diagram Issue A 18 19 Terminal Quick Reference 20 P N 33120C 1997 Radionics Installation Manual 3 Control Communicator Radionics D2812 Control Communicator is shipped from the factory You should receive the parts with your D2812 panel Assembly D2812 Panel D2803 Enclosure D1625 Transformer Technogram Smoke Detectors Compatible with the 33123 Release Notes Firmware Revision 33122 Pack One 2kW Five 1kW end of line resistor for Point 1