Radionics - D7024 Fire Control Panel Operating Instructions

Operating Instructions the Fire Alarm document must be framed and mounted view adjacent to the FACP Service Representative the Built in Keypad keypad built into the control communicator is an alphanumeric LCD keypad It has a two line by 16 character to provide information on various control panel functions In most instances the top line of the display general system status information while the second line describes specific devices that may be relevant the current system status When keys are being pressed the display usually shows the current action on the top while displaying rotating menu choices on the second line A built in sounder is used to annunciate keystroke and as an interior warning device green Power LED is on when AC power is present flashes when the unit is operating from battery power red Alarm LED illuminates whenever the system has an alarm and has not been reset yellow Trouble LED is lit whenever the system has a problem with its wiring or internal circuitry It on even when the trouble sounder has been turning off only when the underlying trouble has been corrected The trouble LED flashes programming mode is active yellow Silenced LED illuminates when an alarm or condition has been manually silenced by the user turns off when the condition that was silenced is corrected Disable key allows the system to disable or re enable notification appliance circuits or relays outputs the dialer Test key allows one of seven special test modes to selected programming the Clear key can be used to exit or exit programming mode entirely Cmnd Programming key will select the programming mode Drill key is used to activate the local notification circuits manually Silence key quiets the bells sirens for an alarm or condition Reset key briefly turns off power to detectors to reset and clears any off normal conditions History key allows the record of system events to be Command key is used to accept data when in mode of System Operation Operation When the system is operating normally it displays NORMAL on the top line of the the Power LED is on steady and no other LEDs are lit If the system is programmed to require a PIN the line of the LCD screen will display PIN otherwise the control panel will bypass this display and show a rotating menu of possible user actions Operation When an alarm occurs the top line of the display will show ALARM This display will any other system display The second line of the display will show the number of the point that is in alarm with the programmed description for the affected point If more than one alarm or other off normal is active they will be shown on the second line of the display one after another The built in sounder turns with a steady tone and outputs programmed to activate with the current alarm condition s will activate Operation When a trouble condition occurs e g wiring for a point is cut AC power fails etc the will activate briefly every 10 seconds The Trouble LED will light and the top line of the display will show TROUBLE The second line of the display will identify the specific problem PIN Numbers On systems that are configured with no requirement for PIN numbers commands such as and SILENCE can be performed by simply pressing the appropriate key once the panel has been opened access the keys On systems that require a PIN number the user must first enter their assigned four digit PIN and then a list of available options will be displayed Once the PIN number has been entered simply press key for the desired command 2001 Radionics a division of Detection Systems Inc Box 80012 Salinas CA 93912 0012 USA Service 800 538 5807 34172D Instructions 2 of 2