Radionics - D9024 D10024 Fire Control Operator's Manual

D9024 and D10024 Analog Fire Alarm Control Panels material and instructions covered in this manual have been carefully checked for accuracy and are to be reliable However the manufacturer assumes no responsibility for inaccuracies and the right to modify and revise this document without notice instructions are the Operator Manual at the Display Control and Limited Programming Levels of See the Installation Manual for information on installation and powering the D9024 and Fire Alarm Control Panels FACP See the Programmer Guide for information on and Level Three operation of the system is used in these instructions to indicate procedures to follow to avoid injury is used in these instructions to indicate procedures to follow to avoid damage to Operator Manual and Cautions Notices 15 equipment has been tested and found to comply with the limits for a Class A digital device pursuant Part 15 of the FCC Rules These limits are designed to provide reasonable protection against harmful in a commercial installation This equipment generates uses and can radiate radio energy and if not installed in accordance with the instructions may cause harmful to radio communications However there is no guarantee that interference will not occur in a installation If this equipment does cause harmful interference to radio or television reception can be determined by turning the equipment on and off the user is encouraged to try to correct the by one or more of the following measures Reorient or relocate the receiving antenna Connect the equipment into an outlet on a circuit different from that to which the receiver is the separation between the equipment and the receiver Consult the dealer or an experienced radio TV technician for help Notices UL listed for NFPA 72 Local references to NFPA and related requirements are based upon compliance with the 1993 edition of 72 National Fire Alarm Code Since installation specifications are nearly always based upon a specific of a standard that has been legally adopted by the Authority Having Jurisdiction AHJ earlier editions NFPA standards will generally apply Consult with the appropriate AHJ for confirmation Radionics All rights reserved The Radionics logo is a registered trademark of Radionics 1800 Abbott Street Salinas CA 93901 USA 01 97 Operation Page 1 of 13 of Contents 1 and Cautions 1 Notices 1 Notices 1 Controls and Displays 4 Control Levels 4 B 1 Level Distinction 4 B 2 Pass Codes 5 Level One Display Functions 5 C 1 Power Conditions 5 C 2 Trouble Conditions 5 C 3 Alarm Conditions 5 Level Two Controller Functions 5 D 1 Power Conditions 5 D 1 a Power Failure Signal 6 D 1 b Power Failure Signal 6 D 2 Trouble Conditions 6 D 2 a Trouble Signals 6 D 2 b Trouble Signal Response 6 D 3 Alarm Conditions 6 D 3 a Alarm Signals 6 D 3 b Alarm Signal Response 7 D 4 Operator Menu 7 D 4 a System Tests 8 D 4 a 1 LEDs Test 8 D 4 a 2 Walk Test 8 D 4 b Time Setting 9 D 4 c Enable Disable Functions 9 D 4 c 1 Enable Disable by Zone 10 D 4 c 2 Enable Disable Individual Detection Devices Inputs 10 D 4 c 3 Enable Disable Panel Keys 10 D 4 c 4 Enable Disable Delayed Day Mode 10 D 4 c 5 Enable Disable Relays 11 D 4 d Print Functions 11 D 4 d 1 Print Devices 11 D 4 d 2 Print Event Log 11 D 4 d 3 Print Mode 12 D 4 d 4 Print Direction 12 D 4 d 5 Print Disabled 12 D 4 e View Functions 12 D 4 e 1 View Devices 12 D 4 e 2 View Event Log 12 D 4 e 3 View Status 13 D 4 e 4 View Outputs 13 D 4 e 5 View Disablements 13 Level Three Programmer Functions