Radionics_-_D2112_D2112E_Installation_Manual

D2112/D2112E Control/Communicator Manual 1/96 Installation Manual 1 1995 Radionics material and instructions covered in this manual been carefully checked for accuracy and are to be reliable. However, Radionics, Inc. no responsibility for inaccuracies and the right to modify and revise this manual notice. a discrepancy is found in this documentation, mail a photocopy of the corrected material to: Communications Radionics, Inc. Abbott Street Box 80012 CA 93912-0012 1995 Radionics, Inc., Salinas, CA, U.S.A. rights reserved. Marking this version of the Installation Manual, we added about the D2112E Control/Communicator. information about the D2112E appears the manual. We marked changes to the design and operation of the panel a vertical line in the margin. An example of the is shown in the margin to the left of this Notices 15 equipment generates and uses radio frequency If not installed and used in accordance with manufacturer instructions, it may cause to radio and television reception. It has tested and found to comply with the in Part 15 of FCC rules for Class B Devices. this equipment causes interference to radio or reception, which can be determined by the equipment on and off, the installer is to correct the interference by one or of the following measures: 1) Reorient the of the radio/television. 2) Connect the AC to a different outlet so the control panel radio/television are on different branch circuits. 3) the control panel with respect to the radio/ necessary, the installer should consult an radio/television technician for additional or send for the Handbook by the Federal Communications This booklet is available from the U.S. Printing Office, Washington D.C. 20402, number 004-000-00450-7. 68 equipment complies with Part 68 of FCC rules. A contains, among other information, the FCC number and ringer equivalence number registered the D2112 Control/ for connection to the public telephone using an RJ38X or RJ31X jack. the ringer equivalence number (REN) to the number of devices you can connect to telephone line. Excessive RENs on the telephone may result in devices not ringing in response to incoming call. In most, but not all areas, the sum the RENs should not exceed five (5). Contact the company to determine the maximum REN the calling area. the D2112 Control/Communicator causes harm to telephone network, the telephone company will you in advance. If advance notice isn the telephone company will notify the as soon as possible. Also, you will be of your right to file a complaint with the FCC you believe it is necessary. telephone company may make changes in its equipment, operations, or procedures that affect the operation of the D2112. If this the telephone company will provide notice in order for you to make the modifications to maintain uninterrupted you experience trouble with the D2112 Control/ please contact Radionics Customer for repair and/or warranty information. If the is causing harm to the telephone network, the company may request that you remove the from the network until the problem is resolved. repairs must not be made. Doing so voids the warranty. not install the D2112 on public coin service by the telephone company. Connection to Line service is subject to state tariffs (Contact state public utilities commission for information.). must supply the local telephone company with following information at their request. The line you are going to connect the panel to Make (Radionics), model (D2112), and serial FCC registration number and ringer equivalence of the panel the panel. Registration Number: AJ9USA-20644-AL-E Equivalence: Center in USA: Radionics, Inc. Abbott Street Box 80012 CA 93912-0012 538-5807 196 Installation Manual 2 1995 Radionics