Radionics_-_D2212_Keypad_Diagnostics

D2212 Keypad Diagnostics the Keypad into the Diagnostics Mode panel sends SERVICE START and SERVICE messages upon entering and exiting Diagnostics Lock the D2212 Standby Switch down. Press the 1 key on the keypad. Enter your passcode. The default passcode is 654321. The default passcode is 3, so if you have not changed the default press 654. the passcode you entered is valid, the keypad scrolls the functions that are available. that you in… you select a function the system displays informing you of test status. Once inside a press CLEAR to return to the previous Test Bell Test powers the external bell with the burglar for 2 seconds. Press the 1 key. The display shows: BELL Bell Test times out after 2 seconds. 11/95 1995 Radionics Test Battery Test causes the panel to run on battery for 4 minutes. During this time if the voltage below 12.2, the trouble tone sounds and the low condition appears in the Check System mode 4). the Battery Test is started, a Low Battery report a Missing Battery report will be sent if programmed. Press the 2 key. The display shows: BATTERY TAKE 4 MIN. test times out in approximately 4 minutes, and results are displayed. If the battery is good, the shows: CLEAR to return to the main menu. the battery is bad, the display shows: TEST TEST CLEAR to return to the main menu. Test Communication Test sends a test report to the If the report fails to be acknowledged after all attempts, the D2212 goes into Communica- Failure. Press the 3 key. The display shows: PHONE TAKE 10 MIN. test times out in approximately 10 minutes, and results are displayed. If the phone line is good, display shows: CLEAR to return to the main menu. the phone line is bad, the display shows: TEST TEST CLEAR to return to the main menu. Programming RF points can be learned, the D208 Receiver be connected to the panel and powered. is possible to encounter RF receiver errors when these operations. An example would be the point code for point 10 as an RF using a receiver on address 8, when there is no connected to address 8. When you attempt to point 10, the system will be unable to communi- to a receiver. In this event, you see the display: REPLY RCVR 8 CLEAR pressing CLEAR, the display will return to the RF Press ( 4 ) to display the RF programming menu. The display scrolls the three RF menu options: LEARN POINTS 1 TEST POINTS 2 REMOVE POINTS 3 To exit the RF Programming menu and return to the menu, press the CLEAR key. RF Points learn a point, you must have previously given it an point code (digits 4 and 5). In the RF menu, press ( 1 ) to Learn Points. If there unlearned points whose point codes have been as RF, the keypad displays the first to be learned (in this example, point 1 is the point programmed as an RF point): POINT ## ]]]]] scroll the remaining RF points, press the C key If there is only one RF point, it will be re-displayed. there are no points programmed as RF points, or programmed points have already been learned, display shows the following. After pressing the system returns to the RF menu. POINTS TO LEARN! CLEAR Press the ] key to select the point displayed. The shows: 1 Press the tamper switch on the sensor you want to as point 1. When the transmission is received, point is learned and the display shows: 1 LEARNED CLEAR the sensor has already been learned into some point, or two points were inadvertently to the same sensor loop, the display the following. In this example, the sensor previously been learned as point 2, although it be any point number: PT 2 CLEAR CLEAR and repeat the procedure using a tha