Siemens BC-35 BE-35 Battery Charger Transfer Extender, Data Sheet

Data Sheet Safety Products AND ENGINEER SPECIFICATIONS Light emitting diode LED Trouble event indicator For lead acid or sealed nickel cadmium batteries System transfer from main power supply to battery mode operation UL 864 9th Edition Listed and ULC Listed CSFM NYCFD and City of Chicago Approved Charger Transfer 3TM Modules BC 35 and BE 35 Automatic operation Battery circuit supervised Extender Overview System 3 Battery Charger Transfer Module BC 35 and the Battery Extender Module BE 35 are each designed to supply 24 VDC emergency back up power to System 3 panel during main power outages models are of solid state circuitry Model contains a yellow Trouble event LED Under Normal conditions the System panel is powered directly from the main power When the system is equipped with power the calcium grid lead acid nickel cadmium batteries are maintained at charge through operation of either Model or the combination Models BC 35 BE 35 circuit the event of an AC power failure the 3 panel is transferred to battery Model BC 35 provides the following features Industry Inc Technologies Division Controls charging current and float voltage values maintain the batteries in optimal condition Provides accurate AC to battery and transfer Shuts off battery power supply source when battery reaches an unacceptable discharge value point Supervises battery placement along with voltage points Withstands shorted battery terminal connections with preventing the possibility of reversed polarity Charging path of Models BC 35 BE 35 are for placement following chart details the battery range for the Models BC 35 and BE 35 Capacity for Model s to 25 AH to 55 AH to 75 AH to 100 AH and one 1 BE 35 two 2 BE 35 modules three 3 BE 35 modules 3TM Battery Modules 3177 capability is provided by a Industry Inc Fire Safety Battery Charger Transfer Module Model BC 35 and when with a Battery Extender Module BE 35 BC 35 and BE 35 must be system by harness assembly and are for use with 24VDC notification Capability is provided to re charge acid or sealed nickel cadmium to their full capacity of main operating power to the system will cause the system to transfer to power After main power has been and the emergency batteries have been recharged the system will subsequently to float charge the back up batteries BC 35 and BE 35 are fitted with a fuse to against the battery from going past normal and accidental reversal of polarity battery shall be protected against overcharge deep discharge Failure of the charging shall be identified by an indicator on the module Model BC 35 and also a system Trouble event if the panel is on AC power Ratings Operating Current charging current Model BC 35 mA mA Model BE 35 and Humidity Range BC 35 and BE 35 are UL 864 9th Edition for indoor dry locations within a temperature of 120 3 49 2 to 32 3 0 2 a relative humidity of 93 2 at a temperature 90 3 32 2 for Ordering 500 884857 500 884859 Charger Transfer Module 2 spaces Extender Module 1 space Diagram Number A A A A A A A A A A A A A A A A A A 24V A A A A A A A A This marketing data sheet is not intended to be used for system design or installation purposes the most up to date information refer to each product installation instructions Industry Inc Technologies Division Safety Fernwood Road Park NJ 07932 973 593 2600 908 547 6877 www usa Siemens com Fire Safety N Service Road Oakville Ontario 0H6 Canada 905 465 8000 www Siemens CA in U S A 2015 sheet dated 4 2011 2