Siemens BTC-1 Backup Tone Card, Installation Instructions

Installation Instructions BTC 1 Tone Card Model BTC 1 Backup Tone Card from Industry Inc provides two tones the MXLV System that can be selected dipswitches This card can be installed on of the ACM 1 to provide backup of the primary tones should the tone generator the ACM 1 fail The BTC 1 can also be on the OCC 1 Output Control Card to provide a default tone when the power riser fails and when the OCC 1 contact with the MMB the two backup tones on switch S1 by SW1 SW4 and SW5 SW8 to the AccuLINK configuration tone selec Table 1 on the next page shows the settings for each available tone additional information on the Voice refer to the MXLV Manual P N all system power before installa first battery and then AC To power first connect the AC and then the battery Remove the card from its protective bag Refer to the function section of the CSG M printout for the tones to be Set the desired tones on switch S1 using SW1 SW4 for the first tone and dipswitches SW5 SW8 for second tone selection Refer to Figure 2 or 3 on page 3 the location of S1 Refer to Table 1 for the switch set and their associated tones Set the tones See Note at the top the next page not install the BTC 1 on the ACM 1 OCC 1 until the system is ready for installation of PC cards Until then the BTC 1 in its protective bag BTC 1 mounts on either the ACM 1 Figure 2 or the OCC 1 See Figure 3 two snap in type standoffs and a comb connector Install the standoffs and comb connector the component side of the ACM 1 or OCC 1 whichever is appropriate Note at top of the next page Industry Inc Technologies Division Park NJ 315 090919 8 Building Technologies Ltd Safety Security Products Kenview Boulevard Ontario 5E4 Canada Mount on an ACM 1 to provide backup for the two primary on an OCC 1 to provide default tone in degrade mode communication to the fails and there is a local detected This is useful if the OCC 1 is providing to the amplifier 1 Backup Tone Card Module 1 the Tones on Switch 1 Switch closed OR ON 0 Switch open OR OFF To open a dipswitch press down on the side of the dipswitch marked OPEN To close a press down on the side of the dipswitch opposite the side marked OPEN open a slide switch push the slide to the side opposite the side marked ON To close a switch push the slide to the side marked ON Position the BTC 1 over the connector standoffs with the components of board facing out Be certain that the and the connector pins line with their respective holes in the card and connector Place the BTC 1 on the standoffs and by pressing them into place takes some effort Be careful be once the standoffs are installed are difficult to remove If it is to remove the BTC 1 from the ACM 1 or the OCC 1 first the system RATINGS 2 the BTC 1 on the ACM 1 3 the BTC 1 on the OCC 1 Industry Inc Technologies Division Park NJ 315 090919 8 Building Technologies Ltd Safety Security Products Kenview Boulevard Ontario 5E4 Canada