Siemens CC-2 (for FireFinder) 2-Slot Card Cage, Data Sheet

Catalog space limited XLS Cage 2 Slots CC 2 Common card cage for all FireFinder XLS fire and voice option cards Two 2 slots to mount any option cards with no Mounts on back box or optional Model CAB MP Removable terminal blocks Numbered terminal blocks All field wiring terminations on top power limited All internal wiring terminations on bottom Molded card guides for card mounting Card position locator label on card guide All cards communicate via common 60 pin power data bus Screw terminals wire sizes supported 12 AWG 24AWG DIN connectors UL 864 9th Edition Listed and ULC Listed Overview CC 2 card cage provides the physical location and all wiring connection for all fire and voice system options cards the FireFinder XLS system cards plugged into the CC 2 card cage with other FireFinder XLS modules a common 60 pin data bus This 60 pin bus through the card cage making all data buses and signals available to cards Connectors are provided on the left side of the CC 2 to connect a 60 pin cable for with the FireFinder XLS operator power supplies and amplifiers There are no active components on the CSFM NYMEA Approved Industry Inc Technologies Division wiring to all devices and circuits terminates the CC 2 card cage All cards designed for use the CC 2 route their field wiring to the of the CC 2 these are all power limited wiring connections distribute 24VDC to or high level audio signals depending on used connect to the of the these connections are all non power wiring connections to the CC 2 are to terminal blocks Terminal blocks are for use with wire sized 12AWG to 24AWG terminal block comes with a protective that also serves as a handle to allow easy removal when wires are connected XLS 6321 continued connector is numbered to make wiring to the correct position on the block simple and reduce the potential wiring errors CC 2 is shipped with two card guides top bottom that mount to the CC 2 PCB The card guide contains a blank label for use by installer to indicate the location or card slot This label serves as a reminder to the to insure the proper card goes in the card slot this is important during when cards may be installed the field wiring terminations have already made also for when cards are removed service field wiring terminations are typically made the CC 2 terminal blocks before the card are mounted and the option cards are CC 2 mounts in one of the four available spaces directly on the back box or CAB MP for installation in the CAB 1 or CAB 3 enclosures FireFinder XLS Cards combination of the following 2 option can be installed in the CC 2 for Ordering to Installation Instruction 315 033035 and Humidity Range are UL 864 9th Edition listed for indoor locations within a temperature range of 49 2 to 32 3 0 2 and at relative humidity of 93 2 at a temperature of 32 2 This marketing catalog sheet is not intended to be used for system design or installation purposes the most up to date information refer to each product installation instructions Industry Inc Technologies Division Safety Fernwood Road Park NJ 07932 973 593 2600 908 547 6877 www SBT Siemens com FIS in U S A Safety Kenview Boulevard Ontario 5E4 Canada 905 799 9937 905 799 9858 2010 sheet dated 7 09 2