Siemens FCA2015-U1 Desigo Fire Safety DACT, Data Sheet

s Sheet Safety Products Fire Safety System Alarm Communicator Transmitter FCA2015 U1 AND ENGINEER SPECIFICATIONS Four 4 separate monitoring accounts available Sends serial data to a central monitoring station Two 2 phone lines available Reports in eight 8 standard communication formats Automatic 24 hour test feature Connects to either a 252 point Model FCI2016 U1 504 point Model FCI2017 U1 periphery board mounts to any of the following up to 252 point addressable panel FC2025 fire or FV2025 voice up to 504 point addressable panel FC2050 fire or FV2050 voice Desigo fire terminal Model FT2050 All programming is made as part of the Desigo panel set configuration Compatible with built in Erasable Programmable Read Only EEPROM system firmware Overview Digital Alarm Communicator Transmitter DACT used to provide communication between either 252 point or 504 point addressable Desigo one 1 Fire Terminal Model FT2050 and either a central or remote monitoring station FCA2015 U1 connects to either the 252 point periphery board Model FCI2016 U1 or the 504 point addressable periphery board Model The DACT enables remote transmission alarms and events via a public telephone line Model FCA2015 U1 supports two 2 and four 4 accounts and can transmit serial including the address of the event to monitoring station Any of the accounts can send Gas Alarm Supervisory Trouble Reset or data or any combination as DACT can perform the automatic 24 hour test by NFPA Chapter 4 Model FCA2015 U1 FM 3010 CSFM 7165 0067 0264 and FDNY Approved UL Listed ULC Listed for central station remote station monitoring UL 864 9th Edition Listed ULC Listed CSFM and NYC Fire Dept Approved communication protocols include SIA DCS 8 SIA DCS 20 Ademco Contact ID 3 1 1400 Hz 3 1 2300 Hz 4 2 1400 Hz 4 2 2300 Hz Data 24VDC current current Design Admissible cross cable 22 AWG Wire ribbon cable connection W x H x D 5 0.8 cm 12.7 cm 2.0 cm Lbs 20g Industry Inc Technologies Division Alarm Communicator Transmitter 6804 and Humidity Range FCA2015 U1 is UL 864 9th Edition Listed indoor dry locations within a temperature of 120 3 49 2 to 32 3 and a relative humidity of 93 2 a temperature of 90 3 32 2 Documentation Terminal and Equipment 252 point system 504 point system Intelligent Voice Communication Sheet for Ordering Alarm Dialer for 252 point and 504 addressable systems of Compatible Alarm Communicators Model FCA2015 U1 dialer can utilize different technologies including Internet IP and Global System Mobile GSM technologies on Siemens fire alarm panels in order to connect to compatible receivers for off premises monitoring IP Station Receiver Compatibility Table following table shows a list of central station that are compatible with Desigo Fire Safety FC2025 252 point and FC2050 504 point systems as well as with Siemens Models 252 point and FV2050 504 point fire with control panels DCS 8 DCS 20 ID 1400 Hz 2300 Hz 1400 Hz 2300 Hz Multiple central station receivers are compatible with the Desigo Safety 252 504 point fire systems Models FC2025 and respectively These receivers also work with Desigo Voice Communication Models FV2025 and FV2050 the table above illustrates central station receivers that been verified by Siemens additional receivers and formats also be used with each of these addressable systems completing the installation communication between Digital Alarm Communication Transmitter Model DACT Central Station Receiver must be tested and verified This marketing data sheet is not intended to be used for system design or installation purposes the most up to date information refer to each product installation instructions Industry Inc Technologies Division Safety Fernwood Road Park NJ 07932 973 593 2600 908 547 6877 www USA Siemens com Desigo Fire Safety in U S A Safety North Service Road Oakville Ontario 0H6 Canada 905 465 8000 www Siemens CA 2015 sheet dated 3 2015 5