Siemens FCA2018-U1 (with Model FCA2016-U1), Desigo Remote Peripheral Module (with RS-485), Data Sheet

Sheet Safety Products Fire Safety System Peripheral Module with RS interface FCA2018 U1 with Model FCA2016 U1 AND ENGINEER SPECIFICATIONS FCA2018 U1 Provides connection to the external event printer PAL 1 Provides an interface to remote printers Two 2 serial ports and one 1 parallel Mounts remotely from the Desigo Fire Safety System Provided in its own enclosure Supervised intelligent module Supports B Style 4 or A Style 6 wiring Fast installation with IN OUT screw using 12 to 18 AWG wire Built in transient protection Downloadable module firmware Built in flash electrically erasable read only memory EEPROM Plain decimal addressing UL 864 9th Edition Listed ULC Listed FM CSFM NYC Fire Dept Approved Overview Remote Peripheral Module Model FCA2018 U1 a means of connecting a Desigo Fire Safety system a parallel printer for creating a hard copy of system status configuration reports This supervised intelligent contains built in transient protection and plain addressing FCA2018 U1 is remotely connected to the Model RS communication bus from any Fire Safety system enclosure Model FCA2018 U1 B Style 4 or A Style 6 wiring and two 2 RS serial ports and a single port that allow connection to the parallel printer PAL 1 Model PAL 1 is used with a Model FCA2018 U1 peripheral module Model FCA2018 U1 super the PAL 1 printer for ON OFF Line POWER ON PAPER PAPER JAM and wiring fault conditions as required UL for NFPA 72 proprietary systems Event report is generated at the operating unit Model on the main Desigo system FCA2016 U1 Dual standardized RS interface that used on 252 504 point control panels RS module provides communication Model FCA2018 U1 for managing and Model PAL 1 Supports B Style 4 and Class A 6 wiring configurations Up to eight 8 devices on the RS Fire Protocol UFP network Electrical isolation between the RS and the Desigo Fire Safety Ground fault monitoring UL 864 9th Edition Listed ULC Listed FM CSFM NYC Fire Dept Approved For PAL 1 connectivity with Remote Peripheral on Desigo Fire Safety 252 point and 504 addressable systems a Model FCA2016 U1 interface must be ordered used FCA2016 U1 is not required for connection a Model PAL 1 parallel printer with a Desigo FC2005 addressable panel because Desigo addressable FACPs each have a built in interface FCA2018 U1 has necessary mounting flanges to the module to be mounted unobtrusively under table or behind a desk Model FCA2018 U1 runs on 24VDC nominal and this source for power be provided from the auxiliary power connection the Desigo system enclosure from other UL Listed 24VDC power sources is Model FCA2018 U1 has screw acceptable capable of supporting a 12 to 18 American Gauge AWG configuration FCA2018 U1 and FCA2016 U1 are FM 3010 7165 0067 0259 and FDNY 6104 Approved Peripheral Module with RS interface 6811 Industry Inc Technologies Division and Humidity Range are UL 864 9th Edition Listed for indoor dry within a temperature range of 120 3 2 to 32 3 0 2 and a relative of 93 2 at a temperature of 90 3 2 Documentation Sheet Number Printer Display Terminals Desigo System Desigo System Desigo System Desigo System markets Desigo System ULC markets for Ordering Remote Peripheral Module Interface Printer Data Receiving Transmitting mode of participants wire length peak peak 8 maximum feet max twisted pair wiring Interface Design Terminal Block screw terminal Admissible to 18 Cable Wire Gauge AWG Interface connection FCA2018 U1 150mA FCA2018 U1 W x H x D FCA2018 U1 FCA2016 U1 W x H x D FCA2016 U1 6.75 2.5 cm x 17.1 cm x 6.4 cm Lbs 794g 0.6 2.76 cm x 1.5 cm x 7 cm Lbs 20g This marketing data sheet is not intended to be used for system design or installation purposes the most up to date information refer to each product installation instructions Industry Inc Technologies Division Safety Fernwood Road Park NJ 07932 973 593 2600 908 547 6877 www USA Siemens com Desigo Fire Safety in U S A Safety North Service Road Oakville Ontario 0H6 Canada 905 465 8000 www Siemens CA 2016 sheet dated 8 2013 4