Siemens FT2007 LED annunciator driver

Annunciator Driver Manual 3 outputs for LED activation of 32 zones 7 control outputs for customized LED display power system fault and ground fault etc 17 inputs for customized application buttons key switches etc Communication with panel through UFP individual address External 24V DC power source required from an UL listed recognized for fire use power limited power supply In total up to 8 UFP type devices connected to a fire control panel Fault On Test Fault On Test built in DC DC DC Industry Inc Technologies Division LED annunciator driver FT2007 U1 is built directly into the same housing as the display panel party UL certified housing annunciator driver FT2007 U1 cable display panel test buzzer Acknowledge key Reset key 6 Connection to 17 inputs Reserved Connection to buzzer Dip Switch for address setting Connection to UFP power supply EOL jumper for setting terminal earth ground Connection to 2 LED flat cable Connection to 7 LEDs Industry Inc Technologies Division Dip switch is used for setting the FT2007 address and Baud Rate The first 1 4 are for setting theFT2007 address the 7 8 digits are for setting UFP baud rate The 5 and 6 digits are reserved for future use switch Rate bps bps bps bps switch to fire control panel FC901 FC2005 19200 bps is required jumper EOL jumper is used for setting terminal resistor of UFP IN OUT resistor is connected resistor is not connected In inch data Industry Inc Technologies Division voltage current quiescent current temperature temperature protocol terminals location DC Nominal 18.8 DC mA mA rel AWG 28 AWG dry device complies with Part 15 of the FCC Rules Operation is subject to the following conditions This device may not cause harmful interference This device must accept any interference received including interference that may undesired operation for ordering No No LED annunciator driver lb For Canadian applications the is deemed supplementary and can be used for display only It must housed in a ULC S527 approved locked enclosure Not approved for UL ULC MNS applications by Industry Inc Technology Division Fernwood Road Park NJ 08932 1 973 593 2600 No Siemens Industry Inc specifications and availability subject to change without notice