Siemens HS Notification Appliances Horn and Horn Strobe, Data Sheet

s Series Notification Appliances Indoor Horn and Horn Strobe Appliances Series Overview Series Fast installation with In Out screw terminals using 12 to 18 AWG wires Synchronization can be accomplished using the Siemens DSC sync modules FS 250 panel XLS panel panel or PAD 3 power supply with built in sync protocol Wall mount flush to standard 4 inch square box double gang boxes or surface mount to back box 4 Wire Horn Strobe Appliance allows for separate operation of the horn and strobe circuits 3 Selectable dBA settings of 90 95 99 dBA Anechoic in both tones Selectable Continuous Horn or Temporal Code 3 Field Selectable Candela Settings 15 30 75 110cd or 135 185cd Listed ULC Listed CSFM NYMEA Approved ADA NFPA UFC ANSI compliant Complies with OSHA 29 Part 1910.165 Audible visual notification appliance shall be Siemens Series HS Horn Strobe and Horn Appliances or approved equals Series HS Horn Strobe and standalone Horn Appliances shall meet and be listed for UL Standard 1971 Emergency Devices for the Hearing Impaired for Indoor Fire Protection Service UL Standard 464 Fire Protective Signaling Horn strobe shall be listed for indoor use only All inputs shall be compatible with standard reverse polarity supervision of circuit wiring by the Alarm Control Panel FACP Series HS Horn Strobe and standalone Horn Appliances shall have a minimum of three 3 setting for dBA Anechoic levels and shall have a choice of continuous or Code 3 audible outputs Series HS shall be of low current design Industry Inc Technologies Division Series Notification Appliances 2576 Strobe portion of the appliance shall produce a flash rate of one 1 flash per second over the Regulated Voltage Range and shall incorporate a Xenon flashtube enclosed in a rugged Lexan lens Strobe intensity where multi Candela appliances are specified shall have field selectable settings and continued be rated per UL Standard 1971 for 15 30 75 110cd 135 185cd The selector switch for selecting the Candela setting shall be tamper resistant The appliance when synchronization is required shall be compatible with Siemens DSC Sync Modules Siemens PAD 3 Power Supplies with built in Siemens Proprietary Sync Protocol The strobes shall not drift out of synchronization at any time during operation The strobes shall revert to a non synchronized flash rate if the sync module or Power Supply fail to operate i e contacts remain closed All notification appliances shall be listed for Special Applications Strobes are designed to flash at 1 flash per second minimum over their Input Voltage Range Note NFPA 72 specifies a flash rate of 1 to 2 flashes per second and ADA Guidelines specify flash rate of 1 to 3 flashes per second All Candela ratings represent minimum effective Strobe intensity based on UL Standard 1971 Diagram Shown In Inches Options Industry Inc Technologies Division Data Details for Ordering Including Mounting Options Agency Approvals Approvals ULC FM CSFM 500 636073 HS Horn Hi Multi Candela White HS Horn Multi Candela Red HS Horn Multi Candela White HS Horn Hi Multi Candela Red Refer to catalog sheet 2585 for detailed mounting options X X X X X X HS Horn Red HS Horn White listed approved This marketing catalog sheet is not intended to be used for system design or installation purposes the most up to date information refer to each product installation instructions Industry Inc Technologies Division Safety Fernwood Road Park NJ 07932 973 593 2600 908 547 6877 www SBT Siemens com FIS in U S A Safety Kenview Boulevard Ontario 5E4 Canada 905 799 9937 905 799 9858 2009 sheet dated 7 07 1