Siemens HTSW-1 System Tamper Switch, Installation Instructions

Installation Instructions HTSW 1 Tamper Switch 1 Tamper Switch Model HTSW 1 Tamper Switch is a 3 position switch that monitors the opening the CAB1 CAB2 or CAB3 enclosure and reports a security alarm Closing the door returns the switch to its normal operating position The switch can be out to indicate a closed position for maintenance purposes BATTERY and AC prior to working on equipment your configuration is UL 1076 it requires the HTSW 1 Tamper Switch HTSW 1 mounts into the rectangular slot located in the frame of the backbox of a CAB2 or CAB3 enclosure Refer to Figure 2 for the location of the knockout for the tamper switch BACKBOX 2 Of Knockouts For Tamper Switch SWITCH KNOCKOUT SLOTS 315 033350 4 Industry Inc Technologies Division the outside door of the enclosure opens on the left install the tamper switch on right side of the enclosure If the outside door of the enclosure opens on the install the tamper switch on the left side of the enclosure tamper switch through opening in frame of backbox Refer to Figure 3 quick disconnect wires to tamper switch Refer to Figure 4 Connect one wire to position marked Connect one wire to position marked cable on HTSW 1 into P5 on PSC 12 Refer to Figure 5 HTSW 1 can be used in CAB1 CAB2 or CAB3 enclosures ONE TO COM 3 Tamper Switch Into Opening 4 Quick Disconnect Connections ONE TO N O FOR SWITCH FAIL FAIL FAIL FAULT 12A FAIL 4A FAIL 5 Of Connector On PSC 12 For Switch Plug Industry Inc Technologies Division Park NJ Building Technologies Ltd Safety Security Products Kenview Boulevard Ontario 5E4 Canada 315 033350 4