Siemens RPR-1 Remote Polarized Relay, Installation Instructions

Installation Instructions RPR 1 Polarized Relay indoor use only in dry environment Remote Polarized Relay is an optional accessory for a alarm system control unit that provides programmable contacts This unit allows the fire alarm system con unit to provide emergency control or activation of other in the building such as air handling systems door devices smoke control systems or other functions by the local code and or local authority This unit a form contact which activates from a fire alarm control unit When connected to a polarity reversal of signal circuit there is supervision of the wiring from control unit to the RPR 1 unit DIMENSIONS On Knockouts Ends K O Note is to be done only by qualified personnel have thoroughly read and understood this sheet Disconnect all power into system including batteries Mount backplate as required Attach conduit if required and run wires as required Connect wires from the Fire Alarm System Control Unit shown Connect field wires to contacts as required Apply power to system Check for proper operation of functions NOTES Units to be installed in accordance with the National Code and or local electrical codes Terminal block will accept a maximum of 14 AWG This module is compatible with MXL MXL IQ MXLV FS 250 SXL EX and System 3 Fire Control Panels CAUTION When making installation route field away from sharp projections corners and components of the RPR 1 Controlled device equipment must be within 3 feet of RPR 1 WIRING max 24V nominal unfiltered wave rectified Contact Rating 28VDC 120VAC 120VAC 0.6PF Hole Ground Previous or Alarm Unit Limited Fire Control Signal O Note 1 2 K O Both Ends Run all Power Limited in one end and all Non Power Limited in the other end of the backplate Industry Inc Technologies Division Park NJ Rev G 315 096055 7 Next Device or of Line Resistor Wire Size 18 AWG Wire Size 14 AWG