Siemens TL-30U System 3 Control Module, Data Sheet

Data AND ENGINEER SPECIFICATIONS 3TM Control Module TL 30U Precision timing Light emitting diode LED indicator Delayed signal capability Placement supervised Solid state logic circuitry 864 9th Edition Listed ULC Listed Overview System 3 Time Limit Module Model TL 30U Siemens Fire Safety is designed to provide a time interval between six seconds and 10 Either a signal circuit will activate or after 10 minutes Model TL 30U is also of repeating the aforesaid time operative when a subsequent Alarm signal is received a system utilizing the Alarm feature TL 30U which is comprised of solid state is normally passive with no drawn power an Alarm signal is received When this occurs a binary counter is activated to control the length of the desired time limit continuing the pre programmed sequence of operation sequence may be used for silencing audible devices in order for the system to receive and annunciate subsequent alarms Alternatively an command may trigger a municipal if the alarm source has not been or verified or it can involve the actuation a suppression system i e Sinorix time interval is available in two 2 ranges Six seconds to 20 seconds Thirty seconds to 10 minutes Per UL requirements when time limits are used with devices they shall operate for no less than minutes and no more than 10 minutes units are preset for a five minute time out but can be changed manually Model TL 30U a red LED indicator that will illuminate at the of the timing period The LED will remain lit until module has been reset Model TL 30U module is placement supervised thus a system Trouble command upon removal the system for precise time control of an output signal by delaying actuation or stopping actuation be provided by the Siemens Fire Safety Time Module Model TL 30U Operating with System 3 module shall be system interconnected by a 10 wire plug and harness assembly 3TM Time Limit Control Module 3166 Industry Inc Technologies Division continued time in time out duration period shall be of being set at any precise interval the following time frames Six seconds to 20 seconds Thirty seconds to 10 minutes interval shall be controlled by a solid state binary counter contained in the circuitry the module At the end of the time interval a LED indicator shall indicate completion of the cycle allowing a subsequent Alarm to be received and processed The module shall be reset from main System 3 panel Model TL 30U modules shall be Underwriters Inc UL Listed and Humidity Range TL 30U is UL 864 9th Edition Listed for dry locations within a temperature range of 49 2 to 32 3 0 2 and a range of 93 2 at a of 90 3 32 2 Ratings Current Requirement for Ordering 500 885330 Module This marketing data sheet is not intended to be used for system design or installation purposes the most up to date information refer to each product installation instructions Industry Inc Technologies Division Safety Fernwood Road Park NJ 07932 973 593 2600 908 547 6877 www SBT Siemens com FIS in U S A Safety Kenview Boulevard Ontario 5E4 Canada 905 799 9937 905 799 9858 2011 sheet dated 12 04