Siemens TOCAC Input Class A Converter Adder Module, Installation Instructions

TOCAC Input Class A Converter Adder Module TOCAC Output Class A Converter Adder Module is used to convert 2 Class B output circuits in the TXR 320 Fire Panel to 2 Class A output circuits It mounts under the TXR 320 main fire alarm board near the input terminal 1 TOCAC Input Class A Converter Adder Module all the time 4 Normally Short 5 Normally Open Open 4 5 6 7 5 8 4 S Y A L E R X U Y A L E R M R A L Y R O R E P U Y A L E E L B U O R Y A L E O C O C O C O C Relay Relay Relay 1 ON when not connected to TPR 300 to Relay 3 front panel programming use TCFG 300 tool not UL 864 or ULC S 527 Please refer to Document LT 922SIE details ON ALARM SUPV TROUBLE TROUBLE TROUBLE FAULT FAIL 1 2 3 4 5 1 1 2 3 4 1 2 O P R 3 0 0 M O D U L E M 3 0 6 R E L A Y M O D U L E PORT SPLY TRL COM 2 ON when not connected 24 V supply and interface including power and battery supplies Kenview Blvd Ont L6T 5E4 Industry Inc Fernwood Florham Park 07932 U S A Rev 2 2013 hole for screws hole for screws circuits must be wired from the TOCAC to the main Fire Alarm board For example indicating circuit 1 positive wire and negative black wire is wired from the Class A converter module to the positive and negative terminals of circuit 1 on the Main Fire Alarm board actual indicating zone is wired from the SIGNAL OUT positive and negative to the signaling devices and then wired to the SIGNAL RET positive and negative Specifications Consumption 0 mA 0 mA Kenview Blvd Ont L6T 5E4 Industry Inc Fernwood Florham Park 07932 U S A Rev 2 2013