Siemens VNT-PS Power Supply for VNT, Installation Instructions

Installation Instructions VNT PS Supply for VNT Model VNT PS is used to isolate the ground of the VNT Virtual Network Tunnel the FireFinder XLS system ground all system power before installation first battery then AC To power up connect the first then the battery VNT PS mounts with an attached bracket onto the VNT MP using the hex nuts with the VNT MP VNT PS installs on the left edge of the VNT MP mounting plate Loosen the two on the left side of the VNT that are fastened to the VNT MP then slide the slots the VNT PS bracket onto the studs Tighten the nuts to securely fasten the VNT PS in place Refer to Figure 2 FOR 1 with Attached Bracket FOR 2 the VNT PS to the VNT MP 315 050491 0 Industry Inc Technologies Division 3 is an example of typical wiring for the VNT PS NOT USE NOT USE OF VNT OF VNT NOT USE NOT USE NOT USE NOT USE NOT USE NOT USE NOT USE NOT USE NOT USE NOT USE 2 3 4 5 2 3 4 5 NOT USE NOT USE NOT USE NOT USE FAIL FAIL FAIL FAULT 12A FAIL 4A FAIL LIMITED LIMITED SWITCH WITH TIE WRAP WITH TIE WRAP LANCES INSIDE LANCES INSIDE ENCLOSURE ENCLOSURE 24V 24V LIMITED LIMITED 3 VNT PS Wiring to VNT Voltage Current max Voltage Load Current Current 24VDC 24VDC max RATINGS Application The VNT PS may only be used to connect PSC 12 P N 500 and VNT P N 500 650490 Industry Inc Technologies Division Park NJ Building Technologies Ltd Safety Security Products Kenville Boulevard Ontario L6T 5E4 Canada 315 050491 0