Silent Knight 5235 Remote Annunciator for 5208 Manual

Remote Annunciator Instructions SK 5235 remote annunciator performs all operations It also provides trouble and information and can be used for The control panel can support up six 5235 Remote Annunciators following instructions are a quick reference refer to the control panel installation for detailed system information the SK 5235 Remote UL installations the SK 5235 Remote must be mounted on a dual gang box and all wiring runs must be made 18 gauge wire or larger Use the mounting base that shipped with this You may damage the SK 5235 if you to mount it on an older base mount the annunciator a 4 flat blade screwdriver into the on the bottom edge of the annunciator remove the mounting plate see Figure 1 turn the screwdriver until the plate pulls away from the frame and facing you A square hole is in the mounting plate to run the to the annunciator When all of the wires have been connected the annunciator set the top of the over the tabs on the top of the plate Make sure the wires do not pinched between the frame and the plate Press each corner of the side onto the annunciator mounting until you hear it click You may have to squeeze the annunciator top to to align it while snapping the bottom into place the SK 5235 wire SK 5235 to the control panel Remove power from the control panel Wire the SK 5235s as shown in Figure 2 Set the ID number See Table 1 Reapply power the control panel When the powers up it will display its ID and current panel status numbers 7 and 8 are not for use by SK 5235 Dip Switches Limited 1 Rear Mounting Plate Removal Secure it to the wall using 6 or 8 screws mounting plate should be oriented so the word TOP is toward the top of the 2 Model SK 5235 Connection Each SK 5235 touchpad can be individually supervised the control panel for programming touchpads as 151237 Remote Annunciator Installation Instructions ID Codes installing SK 5235 you must set its ID code Each SK 5235 must be a unique ID code Upon initial power up address of each SK 5235 is displayed on the with address 0 will not be the back of each device is a small 4 position switch used to set the ID code Use the chart to determine the dip switch positions for possible ID code 1 ID Dip Switch Settings Code 2 Switch settings Up On Down Off Not supervised ID numbers 7 8 are not valid ID settings for SK 5235 not use Not valid ID codes 3 the Operator Key operator key ships with SK 5235 see 3 The operator key can be used to user operations at the control panel or without a user code but will not open control panel door All installer operations an installer code To perform user without a user code insert and turn key as shown in Figure 3 3 Operator Key Key Operation Voltage Draw Temperature VDC max mA mA to 120 F 0 to 49 C Meridian Circle Grove MN 55369 4927 or 800 328 0103 763 493 6475 2006 Silent Knight PN 151237 Rev B