Silent Knight 6855 Manual

12 Clintonville Road Northford CT 06472 1610 USA FAX 203 484 7118 www silentknight com Remote Annunciator 6855 an optional 4x20 Remote Annunciator is in Figure 1 The 6855 can be surface or flush Remote Annunciator Installation Document LS10175 001SK E A 07 01 2017 ECN 16 0218 Mounting these steps to flush mount the 6855 The backbox measures 9 3 8 W x 8 3 8 H The can be mounted prior to the complete of the 6855 using any of the mounting shown in Figure 2 holes 1 Model 6855 Remote Annunciator 6855 is compatible with Honeywell Silent FACP s For more information see the FACP Installation manual holes 2 Backbox Mounting Holes Remove knockout holes as needed for wires Figure 3 for backbox knockout locations knockouts Voltage VDC 20 mA mA to 49 C 32 to 120 F W x 11 H x 7 8 D cm x 29.2 cm x 2.2 cm Mounting for back dimensions trim ring W x 11 H x 3 D cm x 29.2 cm x 7.6 cm knockouts Knockouts 3 Backbox Knockout Locations Wire the Annunciator board to the main control See Figure 7 Attach the annunciator and door assembly to as shown in Figure 4 using the supplied the bezel over the backbox and tighten the screws on the bezel Connections the 6855 to the FACP as Shown in Figure 7 4 Attaching Annunciator Door Assembly to Mounting Remove the desired knock out See Figure 3 To properly mount the backbox insert a single into the key shaped mounting hole Do not all the way See Figure 5 Place a level on of the backbox with the backbox level insert rest of the mounting screws shaped hole holes limited 7 SBUS Connections Ensure the power is turned off at the panel Mount the 6855 in the desired location Connect the 6855 to the panel see Figure 7 Use the DIP switches on the back of the 6855 to an ID number to the 6855 see the FACP manual The new 6855 module must be added to the through programming JumpStart will the module automatically Refer to the FACP manual for more information 5 Backbox Surface Mount Holes Connect wires from the 6855 to the SBUS on the FACP as shown in Figure 7 The Model RA 100TR red trim ring kit is available use when surface mounting Place the trim over the backbox as shown in Figure 6 6 Installing Trim Ring Attach the door assembly to the backbox using screws provided Replace the electronic assembly in the backbox 6855 Installation Document P N LS10175 001SK E A 07 01 2017 Knight JumpStart and Honeywell are registered trademarks of Honeywell International Inc