Silent Knight 6860 Manual

6860 Remote Annunciator Installation Document LS10174 001SK E A 07 01 2017 ECN 16 0218 Mounting these steps to flush mount the 6860 The backbox measures 9 1 4 W x 8 3 8 H The can be mounted prior to the complete of the 6860 using any of the mounting shown in Figure 2 holes 2 Backbox Mounting Holes Remove knockout holes as needed for wiring Figure 3 for backbox knockout locations knockouts holes knockouts Clintonville Road Northford CT 06472 1610 USA FAX 203 484 7118 www silentknight com Remote Annunciator 6860 an optional 4x40 red remote annunciator shown in Figure 1 The 6860 can be surface or 1 Model 6860 Remote Annunciator 6860 is compatible with Honeywell Silent FACP s For more information see the FACP Installation manual Voltage VDC 25 mA mA to 49 C 32 to 120 F 12 W x 11 H x 7 8 D cm W x 29.2 cm H x 2.2 cm See Mounting for back dimensions trim ring 12 W x 11 x 3 D 31.1 cm W x 29.2 cm H x cm D knockouts 3 Backbox Knockout Locations Wire the annunciator board to the main control See Figure 7 Attach the annunciator door assembly to as shown in Figure 4 using the supplied Connections the 6860 to the FACP as Shown in Figure 7 7 SBUS Connections Ensure power is turned off at the panel Mount the 6860 in the desired location Connect the 6860 to the panel see Figure 7 Use the DIP switches on the back of the 6860 to an ID number to the 6860 see FACP Manual The 6860 module must be added to the system programming JumpStart Auto will add the module automatically to the FACP Installation Manual 4 Attaching Annunciator Door Assembly to Mounting Remove the desired knock out See Figure 3 To properly mount the backbox insert a single into the key shaped mounting hole Do not all the way See Figure 5 Place a level on of the backbox with the backbox level insert rest of the mounting screws shaped hole holes 5 Backbox Surface Mount Holes Connect wires from the 6860 to the SBUS on the FACP as shown in Figure 7 The Model RA 100TR red trim ring kits is for use when surface mounting Place trim ring over the backbox See Figure 6 6 Installing Trim Ring Attach the door assembly to the backbox using provided Replace the electronic assembly in the backbox 6860 Installation Document P N LS10174 001SK E A 07 01 2017 Knight JumpStart and Honeywell are registered trademarks of Honeywell International Inc