Simplex 2084 Series Remote Emergency Telephone Equipment (B)

ULC CSFM Listed FM Approved NYC Acceptance Alarm Fire Alarm Systems Remote Emergency Telephone Equipment Series Firefighter Telephones telephones provide direct with the Firefighter Telephone master phone When remote phones call the master a call tone is to verify that the request is in process exact may vary depending on master phone Two wire telephone circuits are supervised and Compatible with 4100U Series and legacy 4100 4120 Simplex Firefighter Telephone Controls assemblies are available for Surface or flush mounting NOTE backbox is ordered Or as separate phone sets for plugging into dedicated phone jack stations options Break rod door latch allows access during emergencies Armored cable models to minimize vandalism voice ear caps are sealed with adhesive Push to talk PTT phones provide input control at the phone Magnetic latch models with Warden Station and LED call indicator Additional options are listed on page 3 Accessories Replacement break rod Listed to Standard 864 telephone systems provide two way for facilities where radio communications not be available or are unreliable They are typically during active firefighting conditions during a fire alarm or during fire alarm system inspection and test requires a dedicated two wire circuit typically twisted shielded pair wiring TSP to minimize noise pickup from adjacent wiring Depending on master control up to 6 remote phones and the master can in simultaneous use Additional information can be found Installation Instructions 579 226 and on data sheet which describes 4100U Master phone control ULC listing is applicable to standard remote pluggable phone and phone jack station refer page 3 for agency status per model This product has been approved by the California Fire Marshal CSFM pursuant to Section 13144.1 of the California Health and Safety See CSFM Listing 6912 0026 054 for allowable values and or conditions concerning presented in this document It is subject to re examination revision and possible Accepted for use City of New York Department of Buildings MEA35 93E listings may be applicable contact your local Simplex product supplier for the status Listings and approvals under Simplex Time Recorder Co are the property of Safety Products Westminster Phone Jack Stations EMERGENCY and Trim Surface Mount EMERGENCY FOR and Trim Flush Mount Pull Handle and Break Rod 5 2006 2084 9001 is standard Model 2084 9023 is similar 2084 9001 but also provides an LED indicator powered the remote phone wiring The LED is activated is selected at the Master phone a for the responding personnel to plug in their and communicate with the master Phone Jacks and Mounting Phone jacks are mounted on a steel single gang plate for use with pluggable The front is marked with red PHONE lettering Mounting requires a electrical box 2 51 mm minimum depth wiring is by color coded 18 AWG 0.82 mm2 leads Phones Cabinet Mounted Information Doors and trim are painted red available for surface or flush mounting The doors are in white with FIRE PHONE or other options as shown on 3 Door Option This mounting type provides glass break rod similar to those used in manual fire stations The break rod is positioned inside the door that pulling the door handle breaks the rod and the door to open A standard lock is also provided allow authorized entry without breaking the rod Options Armored cable phones include voice ear caps sealed with adhesive to minimize vandalism are also available with switches that the user to mute the transmitter until talking is Phone handsets are constructed of Cycolac T a thermal ABS material Fire Warden Station This mounting type an armored cable phone and a door equipped a magnetic latch instead of a lock Typical use would where the phone is located in a controlled access area door is silk screened with WARDEN and a red call in request LED is mounted on lower left corner of the door trim View of Remote Phone Cabinet With Pull Handle and Break rod Phones Red Pluggable Phone The 2084 9014 telephone is ruggedly constructed of Cycolac T a thermal ABS material A coiled line cord and is attached Cord length is 5 ft 1.5 m phones are typically stored in a cabinet at the control panel area where they would be located for fire fighters or other authorized They are compatible with commercially storage cabinets Red Pluggable Phone Push to Talk phone is the same as the 2084 9014 except it is with a large and easily operated push to talk located on the inside handle between the receiver transmitter Pluggable Phone 5 2006 Firefighter Phone Backbox and Phone Assemblies for Backbox Mounting Phone Backbox Backbox red dimensions 13 H x 9 11 16 W x 3 1 2 D mm x 243 mm x 89 mm Ordered Separately one required for Firefighter Phone Assembly listed below Phone Assemblies for Backbox Mounting see note below CSFM MEA Phone Phone Marking FIRE ONLY USE latch door with call in red LED door trim and armored cable phone WARDEN Includes phone mounting plate and door assembly some models are agency listed by 4590 Series type number as shown parenthesis These phone assemblies require a 2975 9053 backbox ordered separately Firefighter Pluggable Phones Phone Jacks and Accessories Firefighter Phones 4590 E Red pluggable phone Phone Jack Station 4590 A Standard Phones Accessories With call in LED red pluggable phone use with 2084 9001 or Firefighter Jack Stations phone jack station single gang requires minimum of 2 box depth CSFM MEA NYC CSFM MEA NYC Replacement break rod 10 k 1 2 W End of Line Resistor Harness ref 733 894 one required for each Class B phone circuit 5 2006 305 mm EMERGENCY FOR