Simplex 4006-9121 Installation Programming & Operation Manual Rev B
File Preview
Click below to download for free
Click below to download for free
File Data
Name | simplex-4006-9121-installation-programming-operation-manual-rev-b-8962170534.pdf |
---|---|
Type | |
Size | 1.93 MB |
Downloads |
Text Preview
firealarmresources comT and Trademarks 2005 Tyco Safety Products Westminster Westminster MA 01441 0001 USA in the United States of America in this document is subject to change without notice No part of this document may be reproduced or transmitted any form or by any means electronic or mechanical for any purpose without the express written consent of Tyco Safety Simplex the Simplex logo IDNet SmartSync and WALKTEST are registered trademarks of Tyco International Ser AG or its affiliates in the US and or other countries analog smoke detection is protected by one or more of the following U S Patents 5,155,468 5,173,683 IDNet addressable communications are protected by U S Patent No 4,796,025 IDNet duplicate device detection protected under U S Patent No 6,034,601 WALKTEST system test is protected under US Patent No 4,725,818 Smart horn strobe operation is protected under U S Patent No 6,281,789 Two wire synchronization circuit operation is pro by U S patent No 5,559,492 Information equipment complies with Part 68 of the FCC rules and the requirements adopted by the ACTA On the door of this equip is a label that contains among other information the following product identifier US 5QWAL01B4008 If requested number must be provided to the telephone company the event of equipment malfunction all repairs should be performed by an authorized agent It is the responsibility of users service to report the need for service to our company or to one of our authorized agents Service can be arranged our office at Safety Products Technology Drive MA 01473 Ringer Equivalence Number REN which is 01 for the DACT installed in this panel is used to determine the number of that may be connected to a telephone line Excessive RENs on a telephone line may result in the devices not ringing in to an incoming call In most but not all areas the sum of RENs should not exceed five 5.0 To be certain of the of devices that may be connected to a line as determined by the total number of RENs contact the local telephone For products approved after July 23 2001 the REN is part of the product identifier which uses the format The digits represented by are the REN without a decimal point e g 01 is a REN of 0.1 the DACT causes harm to the telephone network the telephone company will notify you in advance that temporary discon of service may be required But if advance notice isn practical the telephone company will notify you as soon as If your service is discontinued you will be advised of your right to file a complaint with the FCC telephone company may make changes to its facilities equipment operations or procedures that could affect the opera of the equipment If this happens the telephone company will provide advance notice in order for you to make the neces modifications to maintain uninterrupted service trouble is experienced with the DACT please contact Tyco Safety Products at the location identified above If the equipment causing harm to the telephone network the telephone company may request that you disconnect the equipment until the is resolved Dialing Equipment equipment must be able to seize the telephone line and place a call in an emergency situation It must be able to do this if other equipment telephone answering system computer modem etc already has the telephone line in use To do so DACT must be electrically in series with and ahead of all other equipment attached to the same telephone line Proper is depicted in the figure below If you have any questions concerning these instructions you should consult your company or a qualified installer about connecting the alarm dialing equipment for you Jack Jack for the DACT are terminal blocks on the DACT module Refer to DACT Wiring in Chapter 2 of this manual for DACT wiring instructions and Warnings AND SAVE THESE INSTRUCTIONS Follow the instructions in this installation manual These instructions must be to avoid damage to this product and associated equipment Product operation and reliability depends upon proper NOT INSTALL ANY PRODUCT THAT APPEARS DAMAGED Upon unpacking your product inspect the contents of carton for shipping damage If damage is apparent immediately file a claim with the carrier and notify Simplex HAZARD Disconnect electrical field power when making any internal adjustments or repairs Servicing be performed by qualified Technical Representatives HAZARD Static electricity can damage components Therefore handle as follows yourself before opening or installing components to installation keep components wrapped in anti static material at all times FREQUENCY ENERGY This equipment generates uses and can radiate radio frequency energy and if not installed used in accordance with the instruction manual can cause interference to radio communications It has been tested and to comply with the limits for a Class A computing device pursuant to Subpart J of Part 15 of FCC Rules which are to provide reasonable protection against such interference when operated in a commercial environment Operation of equipment in a residential area may cause interference in which case the user at his own expense will be required to take measures may be required to correct the interference REACCEPTANCE TEST AFTER SOFTWARE CHANGES To ensure proper system operation this product must tested in accordance with NFPA72 after any programming operation or change in site specific software Reacceptance test is required after any change addition or deletion of system components or after any modification repair or adjustment to hardware or wiring components circuits system operations or software functions known to be affected by a change must be 100 tested In to ensure that other operations are not inadvertently affected at least 10 of initiating devices that are not directly by the change up to a maximum of 50 devices must also be tested and proper system operation verified of Contents 1 1 System Board 1 1 supply 1 2 Specifications 1 2 Modules 1 2 Expansion Power Supply EPS 1 2 Expansion IDC Module XIM 1 2 and 4006 9806 City Circuit Cards 1 2 Expansion Relay Module 1 2 Modules 1 2 NAC Extender 1 2 Devices 1 3 Smoke Detector 1 3 Detector