Simplex 4081-9301, 4081-9302 External Battery Charger for 4010 (C)

CSFM Listed FM Approved NYC Acceptance external battery cabinet with charger compatible systems requiring batteries larger the control panel cabinet capacity For use with Simplex Model 4010 Fire Alarm panel or Model 4004R Agent Release Control Accommodates up to 50 Ah batteries batteries are separately Cabinets mount close nippled to fire alarm control and can be installed either surface or Control panels are selectable for depleted battery or depleted battery cutout Available with beige or red cabinet panel connection controls charging circuit Control panels periodically disable the charger and a battery test to monitor battery condition Missing batteries or low battery charge problems are and annunciated as troubles at the control Model 4010 Fire Alarm Control Panels allows of up to 25 Ah to be mounted within its cabinet 4004R Agent Release Control Panels allow up to 12.7 Ah to be mounted within its cabinet system applications requiring more battery backup external 4081 Series battery cabinets with charger accommodate up to 50 Ah batteries status monitoring A separate wired to the control panel allows the normally remote charger circuit to be disabled allowing the panel to evaluate battery status Problems such as or low batteries are reported as troubles at the panel battery Depleted battery warnings and or standard battery cutout features of the fire alarm control panels are maintained when to the 4081 remote battery charger This product has been approved by the California State Fire Marshal CSFM pursuant to 13144.1 of the California Health and Safety Code See CSFM Listing for allowable values and or conditions concerning material presented in document It is subject to re examination revision and possible cancellation for use City of New York Department of Buildings MEA35 93E This product not ULC listed as of document revision date Additional listings may be applicable your local Simplex product supplier for the latest status Listings and approvals Simplex Time Recorder Co are the property of Tyco Safety Products Westminster Accessories Series Battery Cabinet with Charger BEFORE Series Battery Cabinet with Charger Type and lead acid only up to Ah batteries ordered 24 VDC Output Voltage Power Requirements to 132 VAC 60 Hz A 120 VAC and Mechanical Range F to 122 F 0 C to 50 C to 93 RH non condensing 100.4 F 38 C maximum blocks for up to AWG wire 3.31 mm2 wires for battery one additional wire for charger control ft 6 m maximum W x 16 3 4 H x 8 3 8 D mm x 425 mm x 213 mm 90 lbs 41 kg 50 Ah batteries Range Connections Requirements from Panel drawing on page 2 7 2009 Product Selection Information Battery Cabinet with Charger Color Description Cabinet with Charger 120 VAC input Selection Reference ordered separately per Battery Quantity Ah Sealed Lead Acid Battery Ah Sealed Lead Acid Battery Ah Sealed Lead Acid Battery Ah Sealed Lead Acid Battery VDC VDC VDC VDC Required Required Required 2081 9287 Batteries will fit in the 4010 cabinet but are also compatible with these battery cabinets Installation Reference 572 mm charger assembly mm wiring area Area conduit entry or wiring in this area 483 mm w 50 Ah batteries mm mm holes semi flush mm stud guides 1 2 13 mm board stud guides 5 8 16 mm board 5 8 mm thick and exposed dimension semi flush mount 35 mm board position for mount Notes Cut conduit entrance holes as required Power limited and non power limited wiring must be in separate conduit AC power entrance is recommended at the bottom right of the cabinet Refer to Installation Instructions 574 199 is a registered trademark of Tyco International Services GmbH and is used under license Simplex and the Simplex logo are trademarks of Tyco International Ltd and its and are used under license 2009 Tyco Safety Products Westminster All rights reserved All specifications and other information shown were current as of document revision date and are subject to change without notice Safety Products Westminster Westminster MA 01441 0001 USA 7 2009