Simplex 4098-9603 ionization smoke detector

SSL Listed UL Listed FM Approved Ionization Smoke Detectors 4098 9603 for Two Wire and Four Wire Bases Peripherals Listed to Standard 268 Listed to AS1603.2 1997 chamber enclosure Louvered design enhances smoke capture by flow to chamber Entrance areas are minimally visible when mounted indicator LED Pulses to indicate power on On steady to indicate alarm diagnostic tests Magnetic test initiates alarm and verifies system Service connections are available for sensitivity testing base options Bases for 2 wire or 4 wire operation Auxiliary alarm relay output Remote alarm indicating LED output remote alarm LED indicator applications requiring ionization detection the detector provides conventional detection in an attractive housing Bases available for 2 wire or 4 wire operation built in magnetic test feature allows service to conveniently initiate a test alarm condition include relay outputs and remote LED alarm indicators Ionization Detector Mounted in Base Reference Locations Locations should be determined after careful consideration of the physical layout contents of the area to be protected Refer to NFPA the National Fire Alarm Code On smooth ceilings detector spacing of 30 ft 9.1 m may be used as guide further detailed installation information refer to publication 574 709 4098 Detectors Sensors Bases Application Manual Current Current Level Source Velocity Range Approval Listing No Temperature Range Range to 33 VDC from fire alarm panel Initiating Device IDC 24 VDC to 86 mA maximum exact is determined by alarm limiting of connected IDC to 1.46 ft 0.4 Mic X Microcurie AM 241 ft min 0 61 m min to 8000 ft 2438 m to AS1603.2 1997 C to 50 C to 95 RH from 32 F to F 0 C to 50 C White to diagram on page 2 2000 Simplex Time Recorder Co All rights reserved 1 00 Product Selection Smoke Detector Bases with detector bases 4098 9682 and 4098 9683 Base with connections for Remote LED Indicator 18 to 14 AWG IDC and LED connections are screw terminals for in out Base with Auxiliary Alarm Relay and connections for Remote Alarm Indicator Base with Auxiliary Alarm Relay connections for Remote LED Must be connected as the only device the IDC to ensure relay operation Accessories Adapter Plate Remote LED Indicator Encapsulated 24 VDC End of Line Relay Plate Mounted 24 VDC End of Line Relay Ratings Single Form For Suppressed Loads Power limited 3 A 28 VDC Non power limited 3 A 120 VAC Connections In Out where required Relay contacts and IDC wiring color coded 18 AWG leads LED wiring screw terminals for 18 to 14 AWG Ratings Dual Form For Suppressed Loads Power limited 1 A 28 VDC Non power limited 1 2 A 120 VAC Connections In Out where required Relay contacts and IDC color coded 18 AWG leads IDC and LED wiring screw terminals for 18 to 14 AWG Required for mounting to surface mounted boxes and 4 flush mounted box May be used when retrofitting existing bases Compatible with 4098 9788 9682 9683 detector bases Mounted on single gang stainless steel plate Required for 4 wire circuits using 4098 9682 base one per select mounting type as required Detector and Base Dimension Reference 7 8 124 mm 7 8 mm Time Recorder Co 1 00 Mounting Reference Box Requirements relay base 4098 9788 octagonal or 4 square 1 1 2 deep gang 2 deep relay bases 4098 9682 and 4098 9683 octagonal 1 1 2 deep with 1 1 2 extension ring square 1 1 2 deep with 1 1 2 extension ring mount reference 102 mm box 102 mm box 1 2 38 mm box depth mount reference mount even with final or with up to 1 4 6.4 mm maximum recess Adapter Plate required for mounting surface mounted boxes and to 4 square flush mount boxes and 4098 9683 a relay module that in base electrical box Detector Bases 9682 9683 Smoke Detector Time Recorder Co 1 00 and the Simplex logo are either trademarks or registered trademarks of Simplex Time Recorder Co in the U S and or other NFPA 72 and National Fire Alarm Code are registered trademarks of the National Fire Protection Association NFPA 1 00 Massachusetts 01441 0001 USA us on the world wide web at www simplexnet com specifications and other information shown were current as of printing and are subject to change without notice