Simplex 4098-9708, -9709 TrueAlarm In-Duct Sensor Assemblies Installation Instructions

BEimplex 9709 TrueAlarm Sensor Assemblies Instructions 1996 Simplex Time Recorder Co specifications other were current as of publication are subject change without notice A A LOW VELOCITY DEVICE PROVIDED WITH SENSOR PASSING BY IT IN THE AIR DUCT TO DETERMINE WHETHER UNACCEPTABLE IS DESIGNED TO SAMPLE THE AIR TRUEALARM ASSEMBLY OF SMOKE EFFECTIVENESS UPON A DUCT SMOKE SENSOR HIGHLY THE DESIGN AND OPERATING CONDITIONS OF THE AIR HANDLING WHICH IS INSTALLED VARIABLES AS SMOKE DILUTION AND STRATIFICATION WHICH EVEN THE BEST DESIGNED SYSTEMS HAVE NO AND PROPER PLACEMENT AND POSITIONING OF THE DUCT SMOKE PRACTICAL OFTEN COMPROMISED WHICH THE REASONS STATED ABOVE THE EFFECTIVENESS OF THIS SMOKE SENSOR CANNOT BE WARRANTED OR GUARANTEED NO CIRCUMSTANCES AS OR REGARDED TO BE A SUBSTITUTE FOR THE BUILDING FIRE ALARM AND DETECTION SYSTEM TO WHICH THIS ATTACHED AS A SECONDARY DETECTION DEVICE THIS DUCT SMOKE SENSOR BE protected by U S Patent No 5155,468 OF CONTENTS DESCRIPTION THE DUCT SENSOR ADDRESS Setting for the 2120 CDT System Use with 4098 9709 only Setting for the 4020 4100 or 4120 System Operation with 24VDC Power for Relay Control SPECIFICATIONS Operation Alarm Indicator Model 2098 9808 Alarm Indicator Key switch Model 2098 9806 Routines to Follow NOTES PROCEDURES Sensor Procedures Sensor Testing Equipment Available Methods Addresses Point Summaries with MAPNET Address Chart 3 Address Label Operation with 24VDC Power for Relay Control Location of Bends or Inlets 8 Location of Return Air Inlet 8 8 9 10 11 Tear Out Sheet 13 Location of Dampers Positioning Sensor Placement Sensor Placement Sensor Sensor Placement MAPNET Operation Communication Net is protected by U S Patent No 4,796,025 following an 8 digit Product ID number denotes ULC listed product DESCRIPTION 4098 9708 or 4098 9709 TrueAlarm ducts Only the 4098 9708 has auxiliary contacts Sensor Assembly designed sample air and detect smoke alarm supervisory and control functions assembly uses the 4098 9701 Photoelectric Sensor not supplied assembly may be used with square ducts from 6 inches to 36 inches wide For ducts 37 to 72 inches wide use duct sensor on both sides of the duct to provide adequate sampling of the air volume housing has a red Alarm LED A pulsing Alarm LED indicates On detailed on using smoke sensors air distribution systems see NFPA 90A procedures Addressable wire pair MAPNET follow are used to install the 4098 9708 or 4098 9709 TrueAlarm Sensor Assembly show how to set the address at each assembly and also how to make electrical only 4020 Fire Alarm Panel 4100 Fire Alarm Panel or 4120 Fire Alarm Panel by a single duct sensors are connected a 2120 Multiplex Communicating THE DUCT SENSOR ADDRESS critical since the 2120 Communicating Device Transponder 4020 4100 and sensor addressing alarms and troubles per duct sensor rather than per zone Each duct sensor has a unique Systems This address within a building The sensor address and location must match up with the address listed in the specification sheets of the 2120 Job Report or Programmer Report specification sheet